© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I have heard that the clutch wear percentage can be checked with SD2 and if it is worn more than 60% it can cause shifting problems.
The 355 has 3 cat sensors, when the slow down light is blinking, a code has been set in the main engine ecu, and will not go away untill cleared...
I have noticed this and other problems with the ignition switches. Replacing it is easy and a straight forward fix.
Ahh too bad this post wasn't a week earlier, as we just finished a 365 service. Looked straight forward, just lots of parts taken off before motor...
Congrats on the car! Brake light staying on could be e-brake lever switch or brake fluid level sensor, try unplugging the level sensor to see...
Nice thread, lots of cool info. Just wondering if it is possible to check the resistance of the coils at the dis4 unit, is there a connector? or...
yessir turkey n stuffing. Those are the teflon bushings. somehow I remembered a similar sized o ring on that same shaft, but I don't see it on...
For anyone looking to learn more about how modern fuel injection systems work, I recommend: "How to Tune and Modify Engine Management Systems" by...
I didn't see the big o ring or the twelve small o rings in the exploded view. Hope you got them in there....or grease wil puke out all over....
In my opinion, removing the cam pulleys is a waste of time, unless you are going to degree the cams. Just pull both cams out with the backing...
take a look at 328 ignition problem thread by ctnbop.....everything looked good, but on a second look he saw that the connector pins were too wide...
ernie-thanks, no sckool like old sckool..... rivee- There are two temp senders, one for the gauge and one for the computer. Don't remember...
When they break, they usually just crack. No real drama. Just use common sense and don't expect them to last through the abuse. As a mechanic, I...
Uhmm since Daytona?
The best way to get readings from wiring without hurting anything is backprobing the connector. As you stated, the lights came on after the oil...
I belive lambda regulation sets when the sensor is out of the expected range for that time, temp, throttle position, etc. since you stated that...
I take functionality over origionality in cases like that.....ooohhh its getting warm.....
From what I remember: The entire mechanism came out through the top of slot. The interior trim around the window needed to come off. The pivot...
From what I have heard, the 550 is louder than a 355, lower deeper rumbly loud. With the center pipe it is MUCH louder.
Sounds like you may have filled the back side of the connector(s) with cleaner, assuming you didn't peel the boots back, and the cleaner is...
