© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Regarding the throttle shaft leakage, the leak would be between the ball bearing balls. That is why they are packed in grease. My engine was...
When you had your carbs rebuilt did they replace the throttle shaft bearings? If not, they may be leaking air. The old beatings were not sealed...
I have had luck with this procedure. I have a piece of granite countertop (go to a granite counter shop and ask for the sink cutouts). Before I...
It's a monumental experience doing this job. I recently completed mine for the second time on my 78 GTS. Each job; removing the carbs, cleaning...
You should be able to move the lever away from the caliper. This should move the piston inward. The cable with the slot on the end should now have...
The connector is held in place by a small raised tab. Get a small jeweler’s screwdriver and insert it between the connector and the plastic. Once...
Years ago I bought two Bosch coils for my 1978 308 GTS with dual distributors, coils and ballast resistors. These are new and unused, but...
It was a long time ago but I had a 84 Saab 900 and I remember that the round tension knob looked similar. Sent from my iPhone using FerrariChat
These are available from Verell at unobtainiumsupply.com Sent from my iPhone using FerrariChat
Good job!
The slip ring goes around the snout and should not move. If you remove the column switch and look at the snout, you will notice some flat and...
Verell at Unobtainiumsupply.com can mold a new cam and rebuild the rest of the switch if necessary.
It could be the actual electrical switch on the back of the ignition lock. These tend to oxidize and the contacts can be pitted from arcing. I...
Switches can be rebuilt with a new plastic pivot end molded on the stalk. Contact Verell at unobtainiumsupply.com
This is all I have ever found
I purchased some seat covers from Tops On Line in Saddle 3218 color. I was very pleased with the quality of the leather. I later purchased a hide...
Before you put the shift detent tool into position, lightly grease the balls, springs and spacers. this will help hold in the parts once you...
Superperformance must have changed from the original Ferrari design. My headers did not have any header shield “tabbed stubs”. They did have...
Those are probably for the air injection tubes which are part of the emission system of the 78-79 USA carburetor cars If you want to put an O2...
At rest, the linkage should be a bit loose. Do not have the linkage touching the ball. Ideally, both linkages should be the same length and when...