© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
On my GTBi the plastic on the disconnect is broken, it was like this when I bought it so I don’t know how it happened, it still works but has to...
Nice mufflers, the bends look very clean. I will do that too eventually.
Ok, I rechecked the coolant temps and have to correct my previous post, on the road the temps move between 90 and a bit below 100 which is when...
I finally drove myBBi for the first time since I bought it years ago, I posted this on the major+ thread but since that is an old thread I decided...
Glad you could recover these original switches, to avoid damage I did install the relays in the door, it was easier than I thought. No hacking as...
Looking for the left hand bonnet grille or wire mesh, new or used. For an injected boxer 512BBi (different than carbureted).
LIFT OFF! Minutes ago the bardot made its first drive since 2012, it was a short test drive of about 25kms. It went well, all things considered,...
Very nice looking wheels, I have always liked the race car look the gold color gives. I’m not completely sure if a special etching primer is...
Does the 365 have the flat square underneath the front fascia as my 512BBi has? If so how about fabricating a tow ring welded on a plate and...
I also feel I should have bought the original ferrari hoses , but there are so many and so costly! I ended up buying the ferrari hoses only for...
Updating, as I did lots of stuff but didn’t take the time to write about it: -installed the new injectors and did the whole “balancing act” again,...
I would add: Invest time to get the transmission leveled and the lift also to pull as vertical as possible (an engine leveler is very useful),...
Haha, good one...
On my 80 308GTBi it is like the above picture of the BBi, the glass has two holes into which four plastic liners/washers (69) are fitted, then two...
We would need a tunnel rev test (joke), very different exhaust note though, congrats!
I’m guessing there is a significant margin of error on the temp gauge, real temp was closer to 45C
Listed on ebay...
Question for the other Boxer owners: How are the a pillar trim pieces held on from the factory? Mine are riveted, the rivets occupy the slit on...
Finished the doors yesterday, and installed the original type speakers I got on ebay. Not the most comfortable day in the garage. [ATTACH] [ATTACH]
Congratulations on the award! I’ve never attended a Ferrar only event, hopefully next year
