© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Hopefully
Sorry, I just find out this morning when I asked him about the installation after I purchased the pump support , these are the pictures he sent...
Hello, For fix the pump on my support is necessary use a usual screw clamp for water pipes that you can purchase in a normal car parts shop,...
Jeff, Fabio recommend securing the support in place by pipe clamp otherwise pump may move out, do you have a picture of finished one. Thanks, Sark
No, I didn't look for it.
Call Mouser if you haven't. what is wrong with them
Dave great, the Ferrari part number 159601 the nuts for manifold is now superseded to 228265 which is nylon lock style to prevent loosening, at...
Thanks Carl, https://www.mouser.com/Wire-Cable/Wire-Protection-Management/Cable-Boots/_/N-apvlc
Thanks for reply, John I contacted him and he is not doing anymore, not much demand.
I there any way to reproduce a set of wiring for injectors without costing arms and legs? as you see in the picture it is so harden and rigid...
then Dave, my manifold is still sitting on the bench, I read somewhere that it is easier to install the injectors on the bench then put the whole...
Jeff, my car is 550, I never had 456 and I don't remember the name of the person owned the business at the time, overall it wasn't a good experience.
Good to know, thanks
Bill, it is looks like
This is what happen when I was trying to take the wheel off, is this part of the engineering ? [ATTACH] [ATTACH]
I don't know the time involved but I got charged $1000 years ago to remove the tank, the most messy part is to drain the fuel.
Dave, no question about the gaskets, but if you gone that far check those valves too, they become sticky and don't operate as should be and cause...
Jeff, years ago I have gone through that ( gas smell ) with Black horse, the valves # 195049 x 3 needs to be replaced, you can not do insitu, the...
Ryan, I checked the belt tension for BOTH banks when the cylinder #1 was at TDC, I don't see any differences on my recording my be old belt. but...
I speak only for my car, having her for 15 years, timing belt tension on the long side on a good days between 80-100 HZ and on bad days non...
