© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
There is an adjustable down position stop in the middle of the door frame that touch the under edge of the glass when travel downwards
both are for upward.
Interesting to know if there are any high milage 355:s still running without a total engine rebuilt, just ordinary maintenance done regularly. My...
My MY97 F355 with the M5:2 engine management system does not have OBD II diagnose system which I thought came with the M5:2. Obviously not. Anyone...
I just did that myself this winter and it was very easy. Take off the lower outside of the door and you easily reach the two stops. Not reachable...
Fixed it by unscrewing the four bolts that holds the entire front light casing a bit. Then it was possible to open up the eye lid a bit more. This...
Tried to take out the left front headlight to exchange the bulbs which seemed to be quite easy acc. to owners manual, but it was not. Impossible...
Fixed the problem today. Now the upper window stop is aligned with the frame again. :)
I did as you proposed to be able to better see what’s happening. I think there is a sync possibility as I noticed that the front guide does not...
There is an adjustable upper end stop on each guide and a fixed rubber central stop for the window in the lower end, but with the window out the...
Took the motor and entire lift system out. Quite easy to remove. Connected the motor to see it operating in detail and the rear lift came out of...
Interesting, do you have a picture or two of this?
Looks similar to my problem on my 355. Rear end of the pass door window is around ½" too low in its upper pos, so I will try do similar adjustment...
Absolutely, I hope it's an alignment issue and will sort that out first. Also a lot cheaper than an ECU box.
Good idea to try before changing the ECU
Were is this ECU located for the car?
No rattle and left window has the same speed as the right. Took the outer part of the door off, sprayed lubrication oil into the gear wire as it...
