© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
mark see the picture. I have send you a private message. geert Jan [ATTACH]
Mark, You need a sort of dental tool to remove the o ring. It is very thin. The other part is the barrel ( I think this is what you meant the...
No idea. I opened first two old MB FD to practice. They where both full with sand . The ferrari FD had a sort sponge looking dirt in it.
I have a few brake cylinder grommets with the following size (see picture) If this fits please send a private mail. They fit on my 400 i...
See the picture. The relay's of the left side fuel pump and cold start have been removeds for testing. The siugnal cable to the starter is removed...
The fuel distributor that you see in the pictures is a fuel distributor from a 400 i. After the fuel pump (in the fuel line) you have a fuel...
Mark, I started a new thread about the FD. This one was about injectors. Sorry luch....
Put back in the small fuel filters on top in the six outlets. Place the fuel pressure regulator on the side. The small metal O rings are to adjust...
In the bottom of the opening of the plunger house is a very thin hard to see o ring. Replace this o ring first. Put the gasket over the lower...
Rebuild the barrel. Assembling from bottom to the top. First replace the o ring at the bottom. Put the metal ring over the barrel slide the fuel...
Clean all the parts in an ultra sonic cleaner. I cleaned the parts in a ultrasonic bath with hand warm water and a little bit of soap in it. Rub...
You can remove all the o rings and metal cups from the barrel. After removing the metal cups you can remove the metal rings which holds the fuel...
Take off the big screw of the Barrel at the bottom. The Barrel can be removed now. Press out the barrel by pressing the lower half down on a...
Remove the six (torx 25) screws at the bottom and two (torx 25) screws on top. On top there are six Allen screws. Dont touch the Allen screws...
Start with read the K Jetronic book so you know how this fine piece of art works. I you dont feel comfortable with fine mechanical work dont...
Mark, If you are sure that al the torx and non torx screws are removed it should open. You can put it on one side and hammer it in the other...
Mark, Knock with a (yellow) plastic or rubber hammer to the side The torx screws on top and the torx screws at the bottom should be removed....
Lunch I did this before. Have 120 on stock now compleet with the right O rings. I have a ad on ferrarichat for these bushings I offer them on...
Good luck for the weekend mark, If its easier for you I can make a list with all the o rings I have. (Just read the front of all the bags)....
Mark, There will be a difference between the 6 port and 8 port FD for sure. The big o rings inside will be different. I had to buy bags of 100...