© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
The exhaust is stainless steel. I just cut off wheel the welds and TIG weld new stainless bolts.
Yes, you can do the seal without pulling the big plate. I pry the seal out. I use a tool made for prying seals out. I do have the Hill Engineering...
Brian is correct. There is an incredible amount of garbage fasteners on undertrays. I don't understand it. How can you loose hardware from an...
I don't use electronics to bleed brake. I use a pressure bleeder. The white crystals are an on going issue. Hot water will break up the crystals...
Nice job. Congratulations.
I have swapped SD ECUs and have no change. I don't have a D-31 to run simulations with.
The relays "trip" so briefly that the fan and secondary air have no time to react. I removed the cover from two old replays and there is a very...
Yes, I have tested the circuit and will rerun some test this morning to confirm my findings. The odd part is the LH circuit reads the same in both...
Good morning FChat. I have a 95 F355 with a very odd issue. When the engine is running, the 1-4 CEL will illuminate and then the 1-4 Slow Down...
FPR leaking into a vacuum line is an excellent find and a sneaky way to have an over rich condition. Nice job.
Sounds like you need an accumulator. o_O
The carbureted Ferraris have no provision for heating the intake manifolds. I have never had any driving issues with Ferraris that could be...
I have had this issue on a couple cars before. If you start in gear and push the clutch, can you come to a stop? If you can, does the car pull...
Here are the pictures.
I will see if I can get a picture. I have used this set up many times and have never hurt a pump. I have had the cars start to run poorly because...
I have had this issue with many old Ferrari injected cars. The tanks have a rust colored residue that is very hard to get out. Sonic cleaning...
You are correct, it can be done but you have to make a "circuit" to get it done. You just can't wire the switch to control the antenna.
That picture is correct but you have to follow the procedure above to be able to take that cable out. The last one I did was a FF. It was slightly...
A radio activated antenna is not factory and the wiring will not work from the switch. While appreciate the desire to be totally original, I would...
No, the release behind the air box is the park lock. The procedure is as follows: The EPB electric parking brake is engaged automatically at each...
