© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Listers, I am coming up on 5 years since the cam belt has been changed in my 308. The milage is about 12k. Over the next week I plan to start...
Listers, I ordered a new speedo sender for my Euro 1982 308. It uses the "brass" style unit. It came from : Italian Car Parts | Ferrari...
Listers, The "new" tie rods are installed. Toe set at 1/16 in. From above you can see I tried to use an offering that was to fit the Classic...
The vendor I got them from listed them as MINI parts and I was working off info from some Brits as you can see the above.
The measurement would mean start to taper at top of the thread.
Listers, Measurements. Old at the start of thread .460. Top of taper. 503 New SOT. 478. TOT. 512 I am not sure I...
Hello, I am wishing that someone has a new FERRARI joint and can measure it. I will come back in a bit with the measures of the joint I took out...
Listers, As several have suggested there is an alternative joint that will fit the 308. It comes from the classic MINI and it is close. The MINI...
Please what do you use for toe in spec's. I will try 1/16. ???
Listers, I have a complete shop and removing them is straight forward. I have only one side off as I wait for the parts. It took about three...
Good Morning Listers, YES the rod ends are INCH. Big surprise. Now to find what fits or give it up and buy from one of the parts guys. For...
Good Morning, any chance you can confirm the thread. The Ferrari is metric.
Good Morning, I have been following your tip and what I have found so far is the part listed with internal inch 5/8 thread. I have not checked...
My 308 is a euro with fog lights or are they extra headlights? They are controlled from the main light stalk and come on with the low beams. They...
Hey, Welllll I was suspicious so I looked and thought it best........ and so it goes.....
Listers, Today I decided to do normal maintenance only 1982 308. Thought I would have a look at the tie rod ends and replace them if needed....
washed the cars cover!
There is ground/location in Southwest Vermont with a parking lot that is circa 1 mile crossed. It has a large grandstand that is empty and...
Wheel well .....correct. I was thinking the opinion was to remove the inner wheel well. That does not seem to be necessary. Cheers
Please what is the best source for a new one?
