© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I do think it should work fine with an MSD. The voltage is not much higher than with the original Dinoplex although the MSD has multiple spark at...
It was not my car but a car i had to repair because it had equal problems as you describe. So i can't comment on how the cap or rotor looks likes...
It looks weird for sure. But what i would be most worried about in this case is why the contacts only show signs of sparks on the outer edge of...
Just to let you know that you are not the only one suffering..... I spend 3 days finding and fixing up leaks as well. It sucks but that's the way...
[ATTACH]
I think they are such low volume parts that replacement will always be expensive. But Ferrari did not really tried hard to make these gears of...
That is a nice looking engine! The cost of the system depends, you can get most of it yourself because it's made out of readily available Bosch...
managed to get a programmable MSD inside a dinoplex AEC101 case. It needed quite some machining (both the dinoplex as the MSD case) to get it in...
I would not worry to much about the cams and just leave them how you set them. It's just me being lazy for not willing to lift the camcovers after...
Looking good! I'm pretty much at the same point right now[emoji3]. A new chain will stretch a bit in the beginning so you will have to check...
You might get it in there but in my opinion it does not fit any Ferrari. The 130 engine is a heavy cast iron block, it's a silky smooth engine...
If you want I can also send you the length of chain needed from my 25ft of Renold blue chain. I have quite some left and would keep it in case I...
For the chain, go for a Renold Synery 06B2 chain (sometimes also called Renold Black box chain). I installed a slightly cheaper Renold Blue though...
I had all the tensioners replaced by SF parts. I had some issues with them though, the small one was the wrong type and the big one was to wide,...
That tensioner is indeed far gone. How are your camshaft? I needed to have mine reground and hardened because of wear. Also I replaced all my...
Had the same thing and I'm quite sure I got 4 of the same sizes of o-rings with different part numbers. One should be size 20.5 and the other...
I just ended up replacing everything over there. Everything was (in my case) to good to be called worn out but to bad to put back in there. I...
If you loosen both nuts you can slide the 2 sprockets of the shaft while pulling the oil pump/water pump case. They are different in diameter so...
Yes it can handle the advance curve. It is a bit more complicated because there is no plug and play option (yet) for it and you'll need to hide...
Honestly I don't really like the system. I have seen a couple with issues and they mill out the distributor to get the 123 in there. So once...
