© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Now just connect your fabricated wiring harness to the existing horn wires (black is negative), turn on the battery power and give the new horns...
The only slightly tricky part is fabricating a wiring harness that connects the existing electrical pos/neg wires to BOTH horns. 12 g wire, heat...
One Hella horn will bolt to the horn bracket and the other will bolt to the compressor bracket. Re-use the 10 mm bolts and the washers/locknuts....
The horns themselves are each held in place with 10 mm bolts and lock nuts. Just loosen and they slide rearward. [ATTACH] [ATTACH]
I never liked the wimpy Euro-sound of the 512TR horns, so it seemed an opportune time to replace them while the steering rack was out. I got...
The rubber bushings fit into these brackets on the steering rack. The bracket openings and the bushings are tapered. [ATTACH] [ATTACH] [ATTACH]
The bolt that holds the splined steering rack and column together fits in the larger groove. [ATTACH]
Here are some other numbers on the 512TR steering rack[ATTACH]
Good thought, but I'm putting in a new rack so I've got to go by eye. I'm having the car aligned after anyway and they will center the wheel if...
I also found some replacements for the tie rod end boots that should work nicely. I could not find replacement OEM boots anywhere. Just a few...
So, hopefully the new bushing will arrive in a few days and I'll post the steering rack install. I plan on getting an alignment afterwards. So...
Once out (or before removal), measure the number of threads that the tie rod end is attached. Do this on both sides and write it down, because...
The rack is bolted to the frame with 4 bolts (two on each side) that fit through a metal sleeve which fits in rubber bushings. Take off the...
Disconnect the toe rod ends. Remove the 19 mm nut and washer from the bottom and then use a tie rod separator tool to get them apart (the tie rod...
Next, put the car on the lift or stands and take off the wheels. Remove the little metal shields that protect the tie rod ends with an 8 mm...
First disconnect battery or use battery cut off switch in front boot. Next, disconnect steering column from rack from inside car in driver's...
Update: I contacted Superformance UK and they have the bushings for $6.85 each. I found a source on EBay out of New Jersey for $6.80 each, but...
I suspect we are speaking about different parts. I am looking for the 8 rubber bushings where the rack attaches to the frame. I spoke with Ray...
Anyone know of a source or cross reference for the rubber steering rack bushings (where the rack mounts to the frame) for a 1994 512TR?
Alex, do you have any source for the 512TR steering rack bushings?
