© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
So I obtained a different remote opener. And this one had all the solder points on the back side of it. So I was able to solder two wires to it...
Hi, Bruce both your mats have shipped. Thanks very much.
Maybe if I get access to a car for proper measurements
Hi Bruce, send me a private message or an email We can work out the details [email protected] Thanks
On the old circuit board I soldered on the back side of the switch. on the new circuit board i'm not able to do that because there's no solder...
sw4 will still work. if I attach at the 10 and 4 o'clock points it will work. Maybe jb weld?
so the white wire came off along with the solder point. I can still use the same block(sw4) solder points that are at 10 and 4 oclock... Other...
Here's the front of it where I soldered the new wires to. the soldering points were much smaller for sure. I was a little leery of doing it. [ATTACH]
Well, I think I figured it out, but what you're looking at in previous pic is the front on both of the circuit boards. This picture here is the...
Alternately, usually you can take the old receiver and install it on the new opener. i'm not sure what you mean by that. if the old receiver...
My garage door opener went bad so I bought and installed a new one. So now since my old remote that i hooked up in the 430 wont work I have to...
I have 3 of each 360 and 430 made up. I can also make them with the Italian colors bar as in the first picture Thanks
Plenty of straps left whoever needs a set they are $125. Easy 20 min install Thanks
From what i can see Modena Lucerna dosent have a phone number
I'd be interested in one as well. If you find one let me know
My sliders are after market. i went that way because it was a trial and error thing.
Here's the 360 cover. This is the first one. It's for sale and I have a few more in process [ATTACH] [ATTACH]
Looks beautiful,,,
@mel and the 360 owners. Yesterday i was able to make a raw pattern for a 360. Give me some time to work on this,,,Thanks
I have 1 left for F430 now and i may go to a shop today to look at a 360 to measure it up [ATTACH]
