© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Pap, The bolts have dry film lubricant applied during manufacture and theoretically do not need any extra lubrication - When the bolts are...
Ernie, All of our records have 6 years traceability minimum - that is stipulated by BSI under ISO 9001:2000. I already have the mechanical...
FBB - Thank you for the apology - I just wish that it could undo all the damage that has been done - I have had countless emails & phone calls...
Jeff, Undersize spacer would be quite unlikely as these parts are 100% inspected and tolerances on this dimension is +/- 0.1mm (The smallest...
FBB - THE BOLT IS NOT SUPPORTED ANY WHERE ON THE SHANK OF THE BOLT PLEASE LOOK AT THE DIAGRAM BELOW. LOOK VERY CLOSELY AND YOU WILL SEE THAT...
Be careful ND - Your question was asking when does 100% thread engagement occur - you will get more turns in reality as the bolt passes through...
I am slowly losing the will to live - Now where is that picture of flogging a dead horse. Take a deep breath......
Now I know how they manage to keep those mag alloy engine covers so nice an shiny!
These are now in production WS015-355 Same as our WS015 spacers but approx 6 1/4" OD. (15mm thick) Just for the record - Our spacers are...
FBB - I am astonished - truly astonished It seems I am wasting my time explaining this as you can not even see something so obvious as the...
Still need spacers for those as well :D
Basically yes - providing the correct bolts are used and again excluding any allowances for losing part of the first & last thread due to chamfers.
Correct - (Excluding any allowances for losing part of the first & last thread due to chamfers)
I'm just waiting for Gothspeed to chime in here - he will be along any second... We are looking into getting a new rubber seal manufactured as to...
Phew - something that we agree on :D Just for the record after doing a few calculations - Standard 348 would have only 10mm of thread...
OK FBB - Lets say we make a set of spacers like you suggest. You have obviously forgotten that as standard you have the thickness of the brake...
No - Not hit a nerve at all - I'm just fed up (like a lot of others who have left) of wrong information being posted - Are you saying that H&R...
Badly written diagnosis There are over 500 sets of these spacers in existence with no problems so far - The design was based on a Porsche...
All of our spacers are are hubcentric - runout and parralesium within a thou -Bolts are always supplied longer to accomodate the new spacer - and...
Im getting some of these - who wants one http://www.slycraft.com/Headbanger.htm .
