© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Yeah that connector is definitely under the centre console where the reverse switch is placed. I'll check the voltages and also if there's any...
Definitely will. As taz355 as also mentioned the same it definitely could be the issue. Thank you.
I have checked the wiring coming from the TCU up to the connector under the reverse shifter assembly. I'll be taking out the dash to check the...
Also wanted to mention that is it normal for not being able to perform the PIS calibration procedure due to this fault?
This is really great information. Thank you sir. I will check this out again. Also where do you get the wiring diagrams? I have the original...
Sorry for the late reply. It was past 11:30pm for me. Thank you everyone for so much information. I will definitely check out everything. As for...
Thanks for the info. I'll have to pull out the dashboard as well now to check the remainder of the harness that runs behind it to the instrument...
Thank you for the reply. I will for however long needed. This is what the test states. [ATTACH]
Edit- But it displays 10v in my case. Not 0v.
Hello all. I have a F355 '96 with the F1 Transmission. The car doesnt shift gears at all through the paddles. It also does not display the current...
Hello. I realize this is an old thread but wanted to know if you got the issue rectified. I have a similar problem but not the same in all...
By any chance does anyone have an exploded view or diagram of the actuator? Mine has a pretty significant leak from where the wires are coming out...
Ye Yes it's a 6pin plug with 5 wires/pins. When you say 5 is the shield you mean it's in contact with ground right? I'll check out the other...
Mainly looking for the clutch travel, clutch travel reference, PIS, selection and engagement min max values. The entire list of the parameters...
Does anyone have the wiring diagram for the clutch position sensor? What readings I'm supposed to get in each pin of the socket. There are 5 pins...
Hello. Great post by Wolfgang and great work being done. By any chance does anyone have the parameters for the 355 F1 TCU on ignition switched on...
No luck with it. Any other thing that comes to your mind??
Edit- do I have to turn off the immobilizer of the car or there is some immobilizer for the tool that I don't know about? If it's for the car then...
Hey thank you for the response. Yes I am using the serial port on the laptop to connect directly to the sd1 tool(no adapters in between). No I...
Hey really great work on this ForzaLaVida. Thank you for putting in so much time and effort. I own a garage in India and have a 1996 355 F1 spider...
