© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Normally down to the last set of 2 gears, so if anyone wants them, give a shout. Steve
Still got a few sets left! And yes seats are good to ruin your back for a few days :)
For now not planning do to more, but I've got 5 sets to go.
Here are some pictures of the 3D printed gears. Took some time and effort, but after a few testbatches it now is a 100% perfect fit, and are made...
I went to a O-ring/seal factory nearby and took the shock shaft and old worn gasket with me. They were very helpfull and interested. A correct...
A friend of mine is going to measure up and duplicate the gear in order to have it ready for 3D printing. Will report progress. Is this a common...
Seeing that on both dampers these 4mm adjuster-shaft seals are completely shot, I don't think they get replaced during a rebuild. The 4mm shafts...
Would be a nice project to make as an aftermarket piece. All the rest is metal and will last forever, so it will always be this that fails...
Being ready to bite the bullit for 2 new rear shocks I decided to open them up and look at what's inside. Easy job with just having to remove 2...
I separated both motors and tested the left and right rail separately... the right side 90° "gearbox" is the verdict. Plastic gear is completely...
Intrax isn't able to help but they had seen the problem before on a maserati 3200gt. The car's accumulators have been replaced a few years ago,...
No you can seperately make the front and rear of the seat cushion go up or down.
I'll try and have a look which switch-action goes where yes!
Ah yes, now I see that G&B are also on top of the diagram :) And indeed, I'll start with checking the wiring for continuity. Thanks, great work...
Thanks! Very helpfull. And I'll have to re-check my 12V testing on the seat motors E & D (for-aft)... it's pin 2 positive and 3&7 negative, and...
Opened up the ECU and that looks good on first sight., nothing burned, no weird solder joints. [ATTACH]
Hi guys, Hoping to find help for the drivers seat problem on my 456M. Every direction works OK besides the forward motion, which goes forward...
Yes rear ones. My front ones are fine.
Took off both dampers which was actually a pretty easy job in less than an hour. With the hydraulic pressure released I can push and pull the...
Thanks! So this is upon assembly of the shock itself, as in a rebuild like DV or Bilstein would do? The thin adjustershaft itself sitting too high...
