© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Brining this thread from the dead, but I need some help with adjusting my shifter linkage. A lot of people are not active anymore here to answer...
Could anyone send me videos of where each gear should be at??? :confused:
Elliot I was trying to figure out what gear I was in and I can't figure out, probably spent over an hour under the car trying to figure it out. I...
Do any of you guys know the position of the transmission shaft to every gear from the shifter there? Because I might have moved the link to the...
Do you remember how you replaced those? What's the proper procedure to do it?
The nuts holding the sandwich were not loose. The actual stud plate came apart from the rubber block. Seems like a poor design, and just glued...
Thank you for the responses guys. Much appreciate it!
I just recently replaced my crank shaft sensor (fixed the issue). Was testing the car driving it, and suddenly my lever got stuck in 3rd gear....
Ran the car that day but now another problem occured. My buffer 163525 went bad, it came apart while I was in my 3rd gear. had to get home in 3rd....
An Update. Drove the 355 yesterday and everything revs great! Drove the car for over an hour. Not even a slight hesitation. Seems like the problem...
So the sensor on the bottom controls the bank 5-8 actually? wow it's confusing. I wasn't aware that the WSM manual is actually shows incorrectly...
So hold on guys. The lower sensor #2 in the diagram is actually bank 5-8? Im pretty sure the the manual is correct, cause mine didn't have...
Seems like it could be an issue with what you said. I will look into this problem first before anything else. I will work on the car this...
Thanks for the reply guys. Yes all the shims that were on the old one were transferred to the new one.
[ATTACH] [ATTACH]
Hey guys with 2.7 355. I recently changed the 1-4 bank crank shaft sensor cause mine got bad. Replaced it with original Bosch part. Changed it...
Got my new sensor shipped in a week from Britain, and doing an annual oil change as well. [ATTACH] [ATTACH] [ATTACH]
I ordered the original Bosch part on ebay from Great Britain for $50. The shipping is a little longer than a week long which is great! I found...
Yes it's a common issue indeed. On 2.7 there are two of these sensors and on 5.2 there are only one from what I read. Anyway these sensors are...
So recently my 355 started acting weirdly. It stopped going past 5K RPM. And when i would reach 5k RPM the lights on the dash would suddenly flash...
