© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks Guys, I am going to pick up a condensor and try that. I have a spark, but it is either not strong enough to fire under compression or...
1978 308 gts US version. Dual distributors, but now only single points. The car ran fine. I pulled the valve covers off for something...
Nice Charger up in the air....
Thank you both for your responses. the car is Red, but has been painted. it has what I assume is a yellow primer under the red, and I was...
I have looked for info and performed a search. I cannot find my paint code listed anywhere. 1979 308 GTS, carb'd, manufactured Dec 1979....
In reference to the welding up of the block: This brings up the question of the weldings effect on the engine. Ferrari uses a proprietary...
My 79 had the valve failure. distroyed the cylinder (grenaded actually), head, and damaged the cylinder seal land. I bought another carb'd...
Thanks. I stand corrected. My manual shows the same diagram. I just overlooked the second 11. Thanks again, Dan
Guys, my transfer gear assembly only had one thrust bearing for the center gear. I am sure it should have two. the manual does not show two....
You can get just as good of an A/C system using R134 as with R12, if designed correctly. Systems designed for use with R134 work very well,...
Do not over look the point setting. Too much gap will effect the dwell and cause the car to misfire at higher RPM's. I tuned a friends 308...
Thanks for the information. If I could sell them for $500 each I would be happy. It sounds like that is not too far fetched. Thanks, Dan
two of the cams I found numbers on. the other two I could not find them. I will try and look again tomorrow. it is just getting late. the...
Thanks for the input. I will try to remember to get the numbers off of them tonight. If I remember right, they were the same as my 1979 308...
In need of funds to finish my fuel injection kit AND replace my transfer case gear which has damage, I am considering selling some extra parts....
this is a picture of them from another thread. [ATTACH]
Guys, I have seen a few pictures in the past here where people have put the low profile velocity stacks on their Webers. Where can I buy...
I had one let go at around 8000rpms shifting from 2nd to 3rd. My 79 was a daily driver, and it destroyed the cylinder, head, and rod. Plus it...
Birdman, Does that mean the ECM sends out a 12V V8 signal to the tach (vs the earlier 4 cyl signal)? Are the carb'd cars the only ones who...
For all of you who have converted from dual distributors to single or have converted to a DIS system but need to divide the signal to the tach so...
