© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Agree, replacing the vacuum hose is a "while you're there" type job. I pulled the heater and brake booster hoses together (they are both nearly 40...
Below are my notes, I got the gates hose at O Riley I believe. On my 328 I did that job without removing the fuel tank, but on my 308qv the tank...
Tough shift into 2nd when cold is very common on these cars.
3x8 can't be a 348 though...
The lack of undercarriage photos is not encouraging (considering surface rust present on hood).
Found at Gullwing - this is the kind of project I would buy if I wasn't deep into a 308 at the moment. I've had good interactions with Gullwing in...
Looking back at Post #4 it might be possible to resolder contacts inside the switch. I dont have any experience with these switches but might be...
I've been calling and emailing off and on for a few months with no response. He has no idea who I am though, maybe he's swamped with work from...
I feel like I should provide some value to offset my snark; I've repaired dozens of switches in my old bentley using this (DeOxit 5): [ATTACH]
Thanks!
Hi there, I have my evaporator out for testing/cleaning and wanted to ask what folks use to replace the 'glue' that seals the casing together? I'm...
not to be a total jerk, but I'm felling pretty smug about my choice of 308 instead of 328 right about now... :)
I was thinking of installing around this location (red dot in this figure). Also wondering if I should install two cut-off valves. Thanks for any...
Hi there, I'm going through my heater cores and piping and wanted to ask if anyone has ever installed / considered installing a heater shut off...
Had a not-so-fun time removing my radiator, heater cores, and brake booster assembly to send for service. Planning to send the booster / master...
RF axle nut is reverse thread
I picked up these, seem to work great (from Superformance UK) [ATTACH]
Warren I may have a sanden bracket for you if interested, PM me
looks pretty lucky to me
Without seeing the car, and not wanting to give you bad advice, I think it's fine to pull the spark plugs and turn the engine over by hand, make...
