© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Sold
Lots of info here. http://www.ferrarichat.com/forum/308-328-sponsored-yellow-compass-group/318268-washer-motor-removal.html
Expansion Tank (Heater Tank) Ferrari # 109003 Brand new, original steel tank. Vertical mounting. $195 plus shipping. Fits earlier 308 and 208...
Ferrari part # 104528 Brand new Screws into bottom of driver's side fuel tank. Fits earlier models, Dino and carb 308s, may fit some others....
"Next question is how to fit them on the ends of the metal lines. The system pressure is like 3.4 bar so is there a special tool to fit the black...
Contact Verell at Unobtainium Supply Co.—HOME He has the black plastic lines and fittings.
Mine is a September 78 build-one fastener.
Good job. Its always a good day when the fitting comes off and you didn't break anything, and even better when no blood is shed!
I noticed your cover has two Tenax snaps. I have a 78 GTS and it only has one along the left end (Driver's side). No bottom snap. The other end...
Recently saw it listed eBay. Never saw another one listed so I made an offer.
I just happened to pick up a new fuel filter. I will install it in the spring after my tanks are almost empty. Here is what they look like when...
When I replaced mine, you have to be careful with the amount of force applied because you can twist the fitting within the tank. Use a good socket...
1978 GTS Fiberglass bucket before repair. Unfinished fiberglass is very obvious on the inside. The cover that goes on this bucket is made of...
Contact Verell at unobtaniumsupply.com
Correct
I've used this in cars. Good stuff. INSULATOR - BY THE FOOT - 4 FT WIDE from Aircraft Spruce They also have the correct size cotter pin,...
