© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Hi All, As is usually the case, I was under the car fixing one thing (starter) when I noticed both LHS motor mounts were sitting low. I seem to...
I use the NGK DR8EIX in my '84 308. Never had a problem with NGK plugs in any of my cars.
Veso, that looks nice. Even the tacho looks evenly lit, I thought I had seen previous conversions where one side of the tacho was a little darker,...
I always thought aluminium dispersed heat better? But maybe that only applies to comparing engines (cast iron v aluminium heads and block) rather...
Maybe its just me, but those fabricated aluminium radiators look awful! Look like something someone knocked up in their back shed out of leftover...
Do you mean it slipped here? I think from memory there is a locking bolt there that holds the lever to the shaft. And I don't think the shaft is...
I agree with the others, access is tight, but with a flare spanner on the fitting, and a cut down (for clearance) spanner on the filter, they...
Just use a vernier and measure the OD of new new bush vs. the ID of the hole. Its a press fit, so their should only be a few thou interference fit.
Are you sure that's not the outer shell of the old bushing? I seem to remember when I did mine the bushing pressed straight into the aluminum...
Looking great. Is that colour Grigio? For my taste it could sit a little lower
Here's a comparison 308 to think about....
Hi Folks, not sure if this video has been posted here before, but I came across it on YouTube. It's in Japanese, but the pictures tell the story,...
Hi Derek, are you talking USD or GBP?
Mike, I'm not sure those bumper brackets will be doing much in any collision above 10mph! They are too light material with no supporting gussets....
My experience has been most aftermarket shocks/coil overs are stiffer regardless of how they are adjusted. If you want compliance on bad roads...
The much less expensive solution would be straight IDF TBs. There are several manufacturers of these. The type on the left are easier to do the...
Right, well for me the nicest (and as always most expensive solution) would be Jenvey Heritage TBs. You get the good looks of quad carbs but...
Hi Derek, great I'll be interested to see the cost. On the throttle body side what bolt pattern have you designed? This may dictate what throttle...
All great suggestions, that should begin with a good clean of all the that area. Otherwise you are just guessing as there is way to much oil and...
Hi All, does anyone have link to a decent resolution PDF of the 308QV US Spec Wiring Diagram? Much appreciated. BB
