© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Jason, 79 308 GTS here and the same problem. I have tried the silicones and lubricants and they work temporarily but the squeaks come back...
Thanx Mike and dm_n_stuff for helping out. Dan P and I talked this am and cleared up this issue (I hope). Apparently, Stebro sent out 3...
Well, I have only myself to blame for the predicament I now find myself in. After waiting for 5 months (and two incorrect mufflers shipped and...
I have been watching this thread with interest. I have installed in my 79 308 a 1976 dry sump Euro 308 2v engine with P6 cams, ported heads, and...
My wife tells me that I got my muffler shipment from Stebro. I will let everyone know if it fits. (Hope to get to it this weekend) Thanx for the...
Well, it looks as if something that dm n stuff said worked here. I got an email yesterday from Dan at Stebro giving me tracking number and a...
Hi, I thought that I would alert people on this board of the problems that I am having getting the proper muffler for my 1979 308 GTS from...
Thanx all, I will try a bit of JB weld on some of the pitted surfaces on the head and the manifold flange. The manifold castings have a...
Hi, My intake manifolds leak coolant (slightly) where they bolt onto the head. Of course I decided I could not live with it and have pulled...
Thanx all, looks as if I have a 50/50 chance of getting right. Don
When replacing the bell housing after a clutch job, the middle transfer gear of the three (it has no shaft attached to it) fits in place on the...
Oh just saw that you have a single distributor conversion and assume that the engine ignition set up is now one 8 cylinder engine instead of two 4...
Doug, the 7 degrees setting is your static advance timing (at idle- 900- 1000 rpm). The advance alluded to above is the advance that occurs...
Steve, that is a great idea. The only difficulty will be in trying to get the two optical readers exactly 135* apart from each other. Now all I...
Hi, I am looking for the dwell angle/point gap for a single Euro distributor setup on a '76 drysump engine. It has two sets of points in the...
Dave, as 4re gt4 points out you actually can't sand the carb tops on a flat surface in a figure 8 pattern as the cast supports for the float...
Well, Once again I have gotten some great advice from this board. 4e GT4, you had it nailed. Instead of a large file which would work I tried a...
79 308GTS Just noticed that 2 of my 4 DCNF carburetors have warped tops. One is very badly warped, one side seals to the body therby causing the...
Chris, Do you have pix of the flowmasters for $607? Did you go with a single exhaust or a dual exhaust? SS or mild steel? Probably is mild...
Russ I am interested in this thread as I am in the market for a free flowing exhaust as well. If there is any advantage to be gained by...
