© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Maybe a professional upholstery can clean it, but I noticed wear and tear too. Here is before: [ATTACH] After: [ATTACH] It is better but not...
Ok, so if you turn the idle screw in until the rpm decreases at a steady rate, then pushing the throttle slightly, does the rpm rise at a steady...
The fabric is actually two colours if looking closely. The lighter of the colours is very difficult to clean, so I did not fix this on my 328....
Not familiar with the stain removers out there, but I used regular soapy water with a really soft brush to get all the dirt out. Of course, I...
Air leaks are not easy to see. You need to disconnect the hoses and test for vacuum in each line. You can also see if the hose is cracking. Of...
It sounds like air is leaking in from the outside bypassing the air plate. When the control pressure is low at cold the car runs ok with normal...
Is the fuel pump or filter old ? Maybe the system pressure is too low. Any air leak ? There are plenty of hoses ...
Usually you need some resistance in the circuit from the coil to the plug and back. This will allow for a nice, good duration spark. If the...
I was thinking the rpm at 1000 is about 17 revs per second and two for each spark. It is similar to some of the spark sounds in the video.
It sounds like static electricity. The stalling part could be related if too many cylinders do not ignite every cycle. I also agree that belts...
Mixed up ignition coils maybe?
Hi, I know I had to remove the screws and carefully pull out the two pins on the white bar from the housing. I was afraid to break something but...
I did not apply any sealer, but I made sure all surfaces were clean and without scratches.
The intake gasket is a pain to remove ... but I guess it might be different on different cars. It will look amazing when the cleaning job is done...
Maybe there is a too large voltage drop in the fuse/wiring/relay. The coil might not create enough power in the magnetic field.
Try measuring the resistance of the clutch electromagnet. I do not know what it should be, but maybe the current is too high causing it to get...
I guess the obvious things would be to check the mating plates for grease, oil etc and the gap between them. On the Sanden sd507 the gap should be...
Is it a Sanden compressor?
The idle state is really just an engine running at 1000 rpm or similar. The plate is pulled down by the vacuum from the pistons pulling in the...
The sensor plate should not travel more than about 2mm until the lever mechanism touches the plunger. If the plunger is always in contact with the...
