© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I ended up ordering these from Fabspeed with a better package price with headers (had both in stock). Hopefully my stock one can be sold to offset...
I made my decision on the exhaust today. Thanks to some good pricing negotiations from Jeff at Fabspeed and George at Top Speed, this is what I am...
Bradan is not currently making a 5.2 Y pipe. I talked to them today. From my understanding they made a rough prototype but it would throw a code....
I have read some bad feedback on certain companies that are or have done them this way in the past. Not really on my list of options (may be fine...
Looks like you have the 2.7 Y-pipe? I need a 5.2....
I would rather do something that eliminates the heat shields than go this route because I want to see the headers and know their condition at all...
You did use the Fabspeed heatshields that come with the headers though? When you say full catless, what did you do with the secondary cat pipes...
I want to get some opinions on what I should do in regards to my headers. It appears that my stock headers are good, so I have some options. Since...
I am looking into replacing my stock secondary cats (y-pipe to bypass valve) on a 5.2 355 with a "test pipe". Since my original exhaust ideas...
Start of with a compression and leakdown test. This is going to get you the answers to the most expensive problems you may have bought. Make sure...
Well, the Agency Power 360 headers are not going to fit unfortunatly. They do not clear the subframe due to being too bulk where the 4 tubes come...
Yeah, that is why it is hard to find info on. Almost all the leakage info I could find was a normal leakage test with the heads on. I just did not...
Thanks, thats the number I was looking for.
From everything I am reading so far 6% would be ok.?? Of course I am only finding this info on other engines and they say up to 15% and then it's...
What is an acceptable amount of leakage using the plate over the cylinder? What is on the bottom side of that plate to create the seal? A gasket...
Great info, I have not had time to read the WSM section on this yet. I will try to read through that portion tonight if I get home early enough. I...
Leak down and compression tests through the spark plug hole will do me no good at this point since the exhaust valves were whistling dixie on the...
PM me. Out of respect for the other parts sellers I also buy from, I do not want to post here.
I am not trying to give an opinion as I said and I don't want anyone here taking my opinion on this and I really do not want any more discussion...
I have to admit right off the bat that I have not had time to research this manually yet, so this may have already been discussed, but............
