© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Well, now we have a really big problem. I'm depressed. While out on the third low rev shakedown cruise, there suddenly came a high pitched metal...
Bad fuse. Both fans were working and drawing 13-14 amps. Glow fuses kept blowing. Replaced with a standard 20A blade fuse and voila, problem...
I have a 20 lb tank of Freeze-12 that I've used on this car since 2005 with good success. The system needs ester oil, same as Freon. I also have...
How much Freeze-12 or Envirosafe coolant is the equivalent of 2.86 lbs of R-12 to fill my AC system (1994 512TR). I have both available. Do I...
Glow fuse on the left in both pictures, "regular" blade fuse on the right. [ATTACH] [ATTACH]
Well, there you go, that makes sense. Do you have an opinion regarding glow fuses? As far as I am concerned, this issue is resolved and I'm going...
Qavion, your diagrams are professional quality. When I print them off, they are way too small to read. How can we get the final draft blown up...
Let me preface this reply by stating I am the LEAST experienced of all previous posters. I replaced the condensor fans in 2014 because the 20A...
OK, I thought there was a separate thermoswitch for the ac fans but it makes sense that this is tied to the coolant temperature, but if this were...
If I am reading your magnificent diagram correctly, 12v power comes from battery via red wire to fuse #3 on main board (20A) then to relay B...
Wow, that is a work of art. I have a few questions: #11 - thermoswitch on radiator for cooling fans - where is this in the car? There is nothing...
Steve, there is no visual or tactile access to the condensor fans in the 512TR without removing the front bumper. It's not difficult, just...
I am so close. So close. I had 3 error codes on the LH bank (cylinders 7-12). They were injector #4, injector #5 and 1211 which is Lambda...
I found this on Amazon last night. It should work perfectly with two ring terminals crimped onto the ends. I have a crimping tool for the job....
Can you get to all of them through the gaps?
Wow, that's a tough one. I can't see any way to get penetrating oil past the pressure plate and directly to the splines given the limited access...
Another suggestion by Tim Fulmer would be to crimp two large ring terminals on the ends of the 8 gauge wire and then connect those via some...
That makes sense, too flash. I have this three hole terminal block in my box of electrical components, but the set scerws will still tend to just...
You won't get any argument from me. In retrospect, I have no idea why I cut that wire in the first place. Maybe I will look into just running a...
