© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
So the question now is does anyone know the type of compression fitting that connects to USA secondary air pump braided SS hose.
Thanks trev,. And college boy you were correct from the outset! So much for reading threads here. Fascinating, so these with no pre cats and SS...
Found a few on eBay. Some sort of valve on the end maybe a back flow preventer. Not the same connection as USA looks like a hose slips over the...
I believe some years do.
So my manifolds had loose precats. I decided to go with euro manifolds as they maintain the stock look, and don’t have precats and were cheaper...
I’ve done a couple and never noticed that. How is it preforming, starting, and idling? Did they change the oil also (maybe different viscosity...
I’ll look into it, from what I understood, the oil base burns off and it’s the copper that acts as the anti seize agent. I haven’t heard of...
Mine is a 360 so sme may be different. In the 360 WSM they are specific and state install them dry into the head I couldn’t find a torque for the...
Great point. On a related issue there was a thread a few years back of one or our members with cavitation from a cylinder head causing a coolant...
Videos can be instructive but I’m from the era of written instructions with occasional pics. Can’t speak for this video because I didn’t watch...
Perhaps if you post this same question in the 458 section you would get some very different responses. Posting in the 360 section may be skewing...
Carefully Use heat on the aluminum housing not bushing, it will come. I just did mine, I needed heat to remove, and also to install new one. I...
ECU’s reprogrammed thanks to Trevor and now Sam. They can do it remotely via cables to a PC that connect to your Ecu’s. I guess you don’t even...
Thanks to giggles Pisano. I was just going to epoxy the weak spots and paint silver. Better shields make more sense. I covered both sides just...
Luck is on your side! [ATTACH] Sent from my iPhone using FerrariChat
Thank goodness for a good snap on press, if I had to do more than one I would have purchased the hill tool. Couldn’t justify 200 bucks for one...
My n=1 on this (maybe 2 if you count 2 mounts on 1 car). I can remeasure after I get the transmission back in. Perhaps you can check the search...
This brings up interesting points: Brian, you probably don’t have first hand experience muffing up an engine but since you are one of the most...
[ATTACH] Without transmission. I suspect will settle when transmission is in. Mine were almost touching. 8mm Sent from my iPhone using...
Thanks, will do! Sent from my iPhone using FerrariChat
