© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I have looked at the Cicognani website that Timo mentioned and they look better than the Superformance items that I have, so I’m going to order...
That’s perfect, thank you.
It looks like a rubber gear lever gaiter, but the round base is too big, the hole at the top too small and the rubber bellows don’t have enough...
Does anyone have any pictures of the bulkhead seal/bellows around the gear selector rod where it goes through the rear bulkhead? My car doesn’t...
The front cover comes off easily enough and the seal should be easily accessible. Paul
This is a picture of the sun visors before I fixed them and you can see that the outer ends are pulled back from the windscreen header trim. When...
When I took delivery of my Daytona, the rods on the sun visors didn’t also reach the mirror. It turned out that the bent rods on the outer ends...
Thank you. I should probably have checked my Classiche folder and it would have told me in there. Can you tell me where I can find the...
My car came with a 9:35 diff ratio installed as a legacy of its days as a race car. I have pulled out the transaxle and I intend to swap the...
Great information, thank you.
Thank you Alex, that is enormously helpful. I have been trying to find a pair of 16” arms, but so far to no avail. I’m going to see if it is...
Could someone please measure the wiper arms on their Daytona and let me know how long they are please (and where you have measured from/to)....
I came across an ARMAN catalogue on eBay but unfortunately it was already sold. Does anyone have a copy that might show what was originally fitted...
I’ve managed to pick up a pair of 18” ARMAN wiper blades to replace my 16” blades, so I now need to find some 16” arms to go with them.
Thank you. The sweep travel is normally changed by swapping the large internal gear wheel in the motor. The gears are the same, but the crank...
I have Arman wiper arms and I’m pretty sure the text is upside down on the LH side arm. However, my arms are rather longer than suggested, with...
It is the length of the arms (centre of the spindle to the end of the arm with the blade removed) that I’m after. Thank you.
Mine are unequal lengths and I suspect they may be too long because I can only fit 16” blades when I believe they should be 18”.
Could someone tell me the correct length for Daytona wiper arms please? Thank you. Paul
I’ve had lots of experience with the Avons and never had an issue with deterioration. You may be comfortable sliding a Daytona on public roads,...
