© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
jeff348, what was the material (leatherette) that you used to recover the interior panels. I've got a spare top that needs new inside liners....
Mine was popping the fuse every time I pushed the button on the console. Bought a used SAAB replacement, fit perfect, just change the connector....
Danny at Dino’s motors in San Mateo.
Remove the 4 screws on the corners and the mesh, frame falls out. No need to cut the mesh. Thanks for your help I was dreading this job. [ATTACH]
OK, I'm really stupid. I just latched my engine hood on my 348. I had unscrewed the junction where the 2 cables ( gas door and interior handle)...
I did this, works like a charm. 20 bucks for a used Saab part, small spacer on the inside of the fuel filler side, adjust the gas lid and no more...
I have the same problem, a/c blows cold but not enough circulation. Interested in what you find. Please post pics. by the way, mine is a 1991 348ts.
I had one of the 2 wires to the sensor become disconnected. Oil pressure gauge was off the chart. Crimped on a new connector and ever since then...
Back from it's major. [ATTACH] [ATTACH]
[ATTACH] Getting new cam belts and water pump, etc, etc. [ATTACH]
Looks a lot like the 348 fuel pump set up. I replaced the the tank seal gaskets, here's a good write up for the 348....
Passenger footwell. Remove floor mat(if you have one), then remove rubber vertical foot pad, cover swings forward. May have 2 screws on top of...
Not sure if this will fit a 355, but here's the part number of the one I used on my 91 348, Egelhof TCD2.Part # 320305S. exact fit .
Im starting the engine today and taking it for a drive. Is the 201 brake system pressure switch in the ABS pump module? I guess it would be?...
m. stojanovic, ohm meter showed 0.4-0.7 ohms, jumped around a bit. Now the good news, I was a little frustrated after the troubleshooting, so...
Had binnacle out, pin 12 (R?H connector) to bulb socket, circuit board side, shows coninuity. Pin 4 R/H connector ground to other side of bulb...
I've run some checks on the instrument lighting binnacle. Ran a continuity check from pin 12 right hand connector to socket that controls brake...
Hey Qavion, could I just put a voltmeter across pins 4 and 12 at the right hand instrument connector and look for a momentary voltage when I turn...
Hi All, Have been working on my 1991 348, brake test light not illuminating and have damaged a warning bulb holder on the dash. The quarter turn...
Hey bcwawright, Do you still have the instrument light with holder available? I'm looking for some, damaged a holder removing it. If you don't...