© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I have an issue with my sensor, see picture. Anyone have any thoughts on how best to repair these broke off wires? I know the circuit board is...
Thanks for sharing, glad you found a good dark color putty to use. The good news is you can’t see it and it is removable if needed.
You might want to check the connector at the sender unit by the oil filter to make sure it is clean and tight. Also check the wires that run up...
When I replaced a damaged deck lid vent, I noticed a dark colored AC putty was used sparingly in a few areas on underside of vent. I also noted...
Replaced AC belt not timing belts.
I had a similar sound and was convinced it was an exhaust leak or valve issue. It turned out to be belt slapping and it always went away after...
It’s no fun taking the blower motor out. I had to take the dash out to get at it. As long as you have it out, you should replace the blower...
Yup, I removed the panel. The picture is from that side. I have benefited from your posts over the years..thanks.
This is a great thread. I purchased the stronger Mondial struts for the front and Stabilus for the rear engine cover. I followed the directions...
Yes, it was full. Thanks for the comment. It’s all good now and working.
Steve, white connectors have no evidence of heating, not even a little discoloration. I measured between green-brown wire and (ground) at the...
Thanks Steve, I read 13.5V on Pin II Orange-Black wires on the 4-pin HVAC connector when car is running and AC on back probing.
So, rather than pretend I did all this correctly, I will admit to my mistakes. First, turbo-joe was correct, I needed a new battery in my volt...
Off to buy a new volt meter as it is reading open circuit intermittent on a copper penny. Will redo resistance readings with a new meter… ARRGG!!!
Resistance measures not looking so good according to work shop manual: Measured at 20 deg C ambient Heater temp contacts 1-2 should read 12,500...
I will test the resistance and respond back. Thanks Steve.
I Could use a little help with A/C not working. I think I should have 12 volts to the wire at AC compressor to engage the clutch but I don't. I...
Restored 77093 from Black back to original factory color of Blue Chiaro Metallic/black leather interior. [ATTACH]
It would be so easy to not respond and ghost you but Im a Boomer and we never did that. So, I gave a ride to a friend the day before this issue,...
Could use a little help. 1988 TR with both doors closed puddle lights and red door markers stay on. I took out the button pins and tested that...
