© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks I will try that when I'm back on it next week. Thank you for the ideas. The carb was set up by a Ferrari specialist a few months ago but...
Thanks for your replies, very helpful
Hi I'm struggling with the Dino again. I ran the engine and got it nice and hot then I removed the plugs and took compression readings 1= 165 2=...
I just spent a few hours fitting these the wiper motor and arms back on the Dino. I made a bit of a stupid mistake, I took the assembly off...
Hi this should be an easy question, following a respray I have been asked to re attach the pininfarina badge, the only problem is that I can't see...
This is a huge thank you for all the great help and advice. When that tensioner resolutely refused to go back into the engine I must admit to a...
thanks fingers crossed it goes back, I will try again Thursday thanks for the photo links, has anyone got photos of timing chain with cover off as...
Hi I was changing the gasket of the rear timing chain tensioner, the Spring loaded one between the heads, I took the cam cover off and marked the...
Hi sorry to trouble you, have removed the cam covers on a 246 Dino and marked the cam positions before I started, I was trying to replace the...
Hi all, I found an oil leak on the front timing tension ;as suggested (thank you - I think��)it's the one closest to the right hand...
Hi
I know it's not my car and to be honest sadly it never gets driven it just sits in a bubble thing. I've just put new handbrake cables on it, and...
Hi sorry it's been ages since you got back in touch with me over this problem oil leak. Taken the cam cover off today and the engine builder has...
Thanks for all of your help. The Dino is in England so hot climate isn't an issue but I will try to ensure the the hoses are positioned away from...
Thanks for your reply. Is 41 rubber pipe all the way from the T to the heater valve on the heater box? The Dino I'm on has the home made copper...
Hi all, Just in the process of changing the two coolant hoses that run through the middle chassis rail of the Dino (front to rear). On one of...
Thanks, I figured it out there was a metal plate screwed directly to the post on the trunk lid, the plate couldn't touch the pin I got in the...
Hi thanks for your help
Hi thanks for the photos, yes I am looking at the contact plate on the trunk lid. I have the lower spring loaded pin. Just to clarify is the base...
Hi I was wondering if anyone out there could email me a clear picture of the number plate light contact on the trunk of a 246. I have...