© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Okay, thanks! So it is a ground through the dash warning light.
Hi, on my (non ABS) euro 88 328 GTS I found a wire connected to the backside of both front wheel hubs. It is not connected to the brake pads, so...
The oil that is remaining in the engine after you drain it is two litres. So add eight litres to reach te top of the dipstick.
There are four things never to be done to a valuable classic: 1. Never drive it. 2. Trash it when stone cold. 3. Forget the dipstick. 4. Repaint...
Could be the connection at the blowermotor itselve. Remove the left inner wheel splash guard to reach the connector. Clean, treat with WD-40....
Milage is just the distance the odometer has been counting. The engine may had a rebuild in its lifetime and many other parts have been renewed....
Checked the system today. With the fuel pump running (safety switch disconnected) there is 10,5 V at the vacuum solenoid. I disconnected the...
Steve, thank you very, very much for taking the effort to explain the air injection system to me! Appreciate! The electric schematics are...
These are the two actual switches on my 328 engine, Photo 2003. They are not immersed but live outside the sump, so actual reading of the real oil...
Thanks for the comments Steve and Brian. This is very helpfull. This engine has no Lambda (non catalist), no frequency-valve. (There is no copy of...
Hi everyone, On my 1988 Swiss 328 there are two thermostats located next to the oil dipstick connection to the sump. Part numbers 125857 and...
308i? I assume with K-jet? You mention no starts after warm up. Disconnect the cold start valve after some warm up and try to start then. Just...
I had a bearing failure in my 328 many years ago. There were flakes of copper coloured material laying on the bottom in the oil retainer. So this...
Can be the flywheel pick up sensors. How long are they sitting in the engine? Replace them every 8-10 years. they build up resistance due to age...
Try to spray brake cleaning fluid or starter fluid into the inlet manifold. If it starts there is a fuel delivery problem. Can be pump related;...
This problem sounds like lack of circulation. In another post I they mention a lost rubber pad found in the piping. Tis pad sits on the...
When revving a cold engine the head warmes up fast. The block below remaines cold. Putting more combustion cycles into a cold cilinder head(s)...
Today I tried to waken up the heater switch in my 328. A new one costs about 1400 dollars today so I hope it will work again. No luck so far....
Especially after a hot drive I open the hood. But additionally I wait two-three minutes and then restart for 15-20 seconds. Heating on full...
Possible it is the aircon belt being not perfectly aligned on its pulleys. This makes a horrible sound caused by the belt slipping back and up....