© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Q is not one of the typical bearing additions like CN, C3, 2RS2... SKF does not clarify it. I found the description for Q only in combination with...
Now the wanted SKF LM67048/010/Q is installed. And outside bearing LM11949/910/Q too. Works fine. Thanks to atlantaman for the information.
I use a piece of wood. Here few years ago on a 308 of a friend: [ATTACH] And then air...or I connect the caliper for one Minute again to the...
If you "improperly installed piston" you cant put it in parallel position. So you see your mistake, but it will not correct it. "do not rotate on...
For another car a sheet metal plate is used to keep the piston position: [ATTACH] It fits in the front of 308, but i do not use it. Pic was a...
Yes right. Maybe i will use SKF LM67048/010/VU990 (is in the shop) instead of the wanted SKF LM67048/010/Q.
The values i show above are not important. We do not see the differences between the bearings like material treatment and surfaces. Costs $2...$90...
Ok. I do not care about $20 more or less. And yes i use special bearing grease. Preload/Space will be set.
Yes many will fit. But the best one should be used IMO. As far as i know the oldest one was CK-LM67048 and the later replacement was LM67048/010/Q...
I try to get it in Germany for an 308 GTSi US. But it seems to be difficult even if they show the right one on websites. They deliver e.g. SKF...
Ferrari Tech, ok. I am able to measure it when it is disconnected. "14 x 1.5 inverted flare and 12 x 1.5 inverted flare" is ok for me. I order...
Hi, i want a fuel hose for 348 as a spare part to take with me in the car when driving. Only fore safety and to drive back home in case of a...
Now we have some results. But first the questions: "are you sure that neither front/side nor rear indicator bulbs are flashing?" -> yes sure. "Is...
[ATTACH] (Source: m.stojanovic) 31 is ground 49 is input 49a is output That means: Nothing separate left/right. Left indication is working ->...
Thank you both for the answers. right side is not illuminating at all arrow symbol...i have to look again. Relay is clicking with double speed...
15 minutes ogo: The relay is clicking with double speed on the right side. We know that from other cars when one lamp is defect. But all 3 lamps...
Ok. You mean the manual switch near the steering wheel. I will look for that. (Source: Ricambi) [ATTACH]
Thank you m.stojanovic. Hazard lights work normal. "multi-pin connector of the column switch" is witch one / where ?
Hi, it is a 1991 348 TS Euro. Turn signal left side is working. Turn signal right side not. That means that all 3 lamps outside are not flashing....
Yes possible. This is an old pic 2009 with the 7M950. I think the pulley is original. [ATTACH]
