© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
butyl mastic was a common sealer used in period by manufacturers. Something like Drip-Check might be a better choice although I think I used POR15...
does this help? Mine is an 85 RHD and only had velcro until it failed and a PO added screws. Fed up with that I added the Tenax pin. [ATTACH]
Well engine mounts in 308’s are known to go rotten with age. If Mondi’s are the same then probably worth a look
you mean like this?...
[ATTACH] [ATTACH]
Nothing special about these. I just went to the nearest electrical parts supplier. If you really want to contribute to a Ferrari parts supplier...
Yes but I really think you should really be looking at a schematic. The flow from the high pressure side of the compressor goes to the...
Kinda difficult to get photos of that insitu but I'll give it a shot. IIRC the brackets were far from an exact fit and you need to take out the...
all up not much change from 1000 euro
Well I was hoping for your advice back in August. However, from your last post when you say that this needs a skilled shop to do the calibration,...
So just as a followup to this saga. I shipped the speedo and transducer to DinoParts and Service in Germany who have effected it's repair and...
Hi Adrian, my speedo has failed as well. Similar to many others the needle and odo just stopped. The transducer is OK and I can see a square wave...
OK so now I've replaced the compressor with a real Sanden and the receiver/dryer. I flushed the system with methylated spirits and compressed air....
https://www.classicautoair.com/shop/ac-parts/compressors/sanden-double-v-groove-ac-compressor-134a-top-ports/#&gid=1&pid=4 look closely. WYSIWYG...
My Euro QV is 2.5mm Allen head and two grub screws in the ferrule. Undo both grub screws and the ferrule should just slide off the cables. It's...
Just as a final update on the Retro-Air adventure...The cheap Chinese compressor proved troublesome. Obviously the manufacturing tolerances are...
Well I feel your pain. I had a couple of months of "terse" emails when the two replacement hoses were both wrong. Must have really hosed their...
Tommy, there are some minor changes to the what's shown in the Retroair photo online but still largely the same as of May. Buying from them wasn't...
24oz or 680g is what they recommended. Although you would want to make sure the pressures didn't go too high while watching a thermocouple in the...
