© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I to looked all over the superformance site for the seats and they have ones for a lot of other models but not the Dino, They have everything...
Hello to all again I am in the middle of a long path in completely rebuilding the heads on a customers Dino, I was able to source all of the...
Does anyone have a line on valves, ( for a reasonable cost ) I am replacing all the valves, ( and everything else ) it still has its sodium filled...
Thank every one for sharing your knowledge with me. So I have pulled the engine and heads off and I am going to get new cams and have the heads...
I completely agree, with the cams starting to wear to this degree, is the start of cascading wear everywhere. And yes there was silicon...
I am working on a customers car and was checking cam timing ( per customers request ) and have found some sketchy looking cams, nothing terrible...
Hello to all I am working on a Euro car #04740 and the owner wants me to put in a updated ignition box as he does not trust the Dinoplex, however...
Thanks for the reply's so far, however I am not talking about the shift shaft itself, I already have that out. I am talking about the cast tube...
Hello to all I am hoping that among the vast knowledge base here, that somebody might know, is it possible to pull the shift shaft tube out of...
Hi everyone You guys have been so helpfull, I thought I might as well ask about door stops as well as have not found anything on my own. The cars...
Hey Ron I will buy it, if you will sell it, how much do you want for it. If you could send it to me at D & B Enterprises 2869 Lotzgesell rd....
Hi Ron thanks for your response, it takes about 43 inches to get around the dash panel, I will gladly pay you for it. As I have had no luck...
Hi everyone I am looking for a source for the rubber edge trim that finished off the gauge cluster aluminum, the car I am working one is torn....
WOW You guys are on top of it, Thank you everybody for all of the good and helpfull info, I suspected as much about falling out of 1st and...
Hello everybody I am working on a 246 Dino and there is a lot of movement in the diff output flanges,I am assuming that this is not right. I have...