© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Hi, thanks, i have to look at lambda value at higher revs. But what kind of failure brings a faulty fuel distributor ? Actually i put a...
Hi, above 4000rpms the engine runs fine. We measured poor running by a lambda measuring system and this shows 1.3 when open trottle. When...
Hi, Sensor position seems ok. Dirk
Oh, i forgot, so hotter the engine so more poor fuel mixture. This depends on lower system pressure when hot, i think. Thanks Dirk
Hi, overhauled heads, new pistons, all new gaskets, nice cpmpression on all cylinders and new injectors. Direct coil ignition, new wires,...
Hi, thanks a lot, part nr. is: 0 438 100 034. I have to look for the sensor position. Thanks Dirk
Hi, my EU 328 starts fine and has normal idle. But on driving when i close trottle and open trottle again, it seems, that the engine runs with...
The lower ones, the oil retainer should be behind the bearing. Thanks Dirk
Is it possible to replace the timing belt pulley oil retainers, in a 328, without engine off ?
Actually there is an oil leak at the timing belt pulley. Is is possible to fix it without engine off ??? Problem should be the oil retainer...
Hi Guys, i just finished ( i thought so ) my 328 engine buildup for my 308QV. I use a 328 Block and the 308 Gearbox, new crank, new pistons,...
Hi guys, i know that there are many threads about this, but i didnt find anything. So, can anybody shortly say which parts i have to remove...
Yes, thats right, but i just build up a Euro 328 engine, because my US Spec 308 engine, has much less power than my 911SC-83. I use the 328...
Try Wieseco, they made some 328 pistons for me with 10.3:1. Ask for Keith Thompson. Very nice price, approx $750 for all
Has anybody replace the oil seals for the gearbox linkage in a 308 ? Mine is leaking a little bit and i cant see in the parts book how difficult...
Thanks a lot Dirk
Is it possible to remove gearbox and cluchhousing complete from the engine without disassemble the clutch and the transfer case ? Dirk
Hi, which is the best place to fasten a rope for pull off the engine of a 328 ? Dirk
Hi, iam a little confused about the 328 Workshop manual. On one sheet they say, You should use 45Nm for the cylinder head nuts and on the...
Hi guys, how can i identify the upside of the 328 head gasket ? Thanks Dirk