© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I think we may of struck gold and found a NOS ECU located in Germany for €2000 , we have ordered it , will update when it arrives , really...
So after a bit of a curve ball at the start I have got to the bottom of this ! I have hooked up the scope to see what signals are coming out of...
I did swap the entire unit including the fluid reservoir so level switches have been eliminated , my plan is to scope the sensors and solenoids...
I have removed the valve and it has been ultrasonically cleaned while being pulsed, the resistance is 4.5 ohms at the 35 way plug on the ECU , i...
Thank you again for your reply , the 12v supply at pin 2 is present at key on and also engine running , we have swapped out all three relays and...
It is a UK supplied car
Many thanks for the wiring diagram , much clearer than the original ferrari one i am currently using !! I currently have the wire to pin 18...
Hi everyone , you will have to bear with me a bit on this one as I’m in pretty deep trying to resolve this problem !! So we have a customers car...
The bolt has snapped off that attaches the rotor to the alloy bell, these bolts are installed by Brembo and should not be slackened ,swapped and...
thanks for all the comments guy's. i have found a company that have had good rate of success with grinding back and metal spraying the seat that...
the reason for wanting to replace the egagement part of the gear is because there are some slight groves forming where the synchro ring sits on it...
I'm currently rebuilding a 308 gearbox due to poor gear change in 2nd and 3rd , i have found some wear on the dog teeth and on the cones on the...
big thanks to mechaniker , the membrane does appear to be leaking , this fault has sent us round in circles although still confused by the...
sorry mechaniker , i've tried to include every detail , even i have forgotten what ive done and writen down !!!
i have already replaced the waste gate control valve as i have mentioned at the start of the thread , i have tried winding the screw out a couple...
We have now fitted the original exhaust back on to the car , although the fault is slightly improved it is definately still present . Have also...
On light throttle the problem does not seem to occur and also if driven hard at high rpm you can stay above the problem . It is most evident when...
I will answer some of the posted suggestions here in one go . It won't be the onset of the second set of injectors as they are triggered...
injectors have been asnu cleaned , the fuel filters were replaced and i also have bridged them out for test purposes toe eliminate. checked all...
the plugs were replaced as part of the service , thought they may be the problem so as they were champion which i am not a big fan of , refitted...