© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
There is a large cable that goes directly to the starter motor. Check this for a tight connection. It may be a good idea to clean the...
You said that all gauges failed; that implies a total electrical system problem. I agree with Thorn that it is most likely a bad ground. Clean...
This comes up properly on my machine. Hope it works for you. https://www.manualslib.com/manual/467028/Ferrari-348-Spider.html?page=8#manual
Turn on the headlights and try to start. If the lights get very dim or go out, you may have a defective battery. Also check the voltage at the...
Try to contact these guys. Your parts are small so shipping should not be a major expense. Plastic Chrome Plating & Electroplating Services |...
Have a look at Don's Bulbs. He may be able to help. donsbulbs Data Specifications Service
Have you checked the timing?
I'll chime in. My car 76 steel 308GTB S/N 20589. Has zippered front bay and notched battery cover. Pictures attached. [ATTACH] [ATTACH]
The spring inside the cold idle device is really rather weak and is insufficient to overcome the friction when the car is at temperature. I think...
My car is an early 308 GTB S/N 20589. Attached are two pictures that show the cold idle mechanism. The first picture is a plan view of the...
This requires building a custom circuit that is installed between the wiring harness to the tank and the fuel level sender. The schematic of...
The buck boost converter must be modified to be useful. It will not operate properly if the desired output voltage is 13.7 volts and the input...
I'm willing to share everything, just wanted to know if anyone else cared. My car is a 76 GTB, but I think this will pertain to other years and...
I have owned my 76 308 GTB for 30 years and suffered in silence as the gas gauge presented me with a variety of readings when the tank was less...
ZEP 40 carried by Amazon. We used to use it to clean optics prior to thin film deposition. There is no better.
Tinterow, thanks, this is exactly what I needed. Regards.
I have been considering having my deck lid repainted but the reinstallation of the grilles worries me. The rivet guns I've seen all seem too wide...
Recently the fuel pump in my 76 GTB became very noisy (bad bearings, I think). So I decided to install a new pump and researched Facet and...
After all these years my shift shaft bellows (rubber dust cover) has decided to retire (hardened and showing a slight crack). My question is can...
I like to know volts and amps, so I installed gauges for both in my 76 308 GTB. I learned a lot about my electrical system and why I always...