© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
whilst your in there have a look at the door plug connectors, plug and base usually have poor connection, rusted, green and cables split. a good...
Parked at a garage (gas station for those NOT in australia) in the 348. Getting petrol and a lady asked my wife, do you like horses. My wife asked...
I get the same virus when i open photos, malware
Hi all, has anybody replaced the leather on lower part of the dash in their 348. It appears the dash is all one piece. I want to replace the tan...
thanks for the suggestion and link. Larry
Thanks Jeff I will see if I can source some Bondloc plastic weld here in Australia. Lazza
348Jeff I like the Maccas option BUT did it come with fries. I will pursue the ashtray repair and put some wire in each section and glue back...
Hi does anyone know where I can get a drink holder as a straight replacement for the ashtray in my 1991 348. see attached pics. My ashtray is...
Hi Guys, pulled my MAFS apart to clean them and found a fair bit of oil inside the tubes, there was enough there to be pooling at bottom of the...
thanks for the great response guys, this forum is great. Where do I get the after market cup holder? part number supplier? thanks once again. I...
Hi guys, took all instruments out and cleaned up sticky bits, where did this bit go again ? in front of ash tray??? I can't remember and its not...
HI guys, I am only just back from the Snowy Mts for a couple days. Sorry about poor updates. Thanks to 2NA, plugzit and Ernie for advice on...
Hi guys a little bit confused, is this bearing you say to check item No 3 or item No 11 on attached Ricambi drawing 348 (1989-1992): Table 6 -...
Hi guys please find pics of some of the bent valves and the repair that has been done to the da### drive pulley fence. (machined a new fence from...
thanks guys straight on to that bearing condition tomorrow. kind regards Larry
thanks guys, success! I have been ignoring that msg :s"how all content" as a PITA, but it wasn't. Well it is but it has a purpose. Now back to the...
Please find attached picture of one of the reconditioned heads received back after refurb. I will put pics of damaged valves up in next couple...
Guys How do we add photos to a thread or post. I have looked and tried and its very frustrating!!
Hi Guys, update on timing belt bottom drive gear fence failure. Found 17 bent valves, sent heads away for refurbishment and have now just picked...
Hi I was looking for a Prancing Horse for the front grill of my 348. is this suitable
