© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Try disconnecting the battery and putting the two wires together that is the negative and positive for 10 sec that does a hard reset on the car....
I'll try to find the pictures I took back then and I'll post them
There is screws and it kind of clips together then it opens like a book your going to see the board is made of plastic sheets look very closely...
Had the same problem tryed relay but problem came back it end up being a weld cracked in the fuse box one of the pins that connects to the relay...
Texa
No they don't, the peaces are shaped like that so they don't grip on the plastic sliding plates .the two notches are positioned on the opposite or...
This is the way the one I did last week came apart. You can see the way the notches should be positioned hope this can help. By the way don't try...
Try wiggling the relay and see if you can make it idle. I had the same problem the pin connecter where the relay goes into the fuse box one of the...
The 288 gto wow didn't know he had one wonder if it's still in Montreal?
Thanks for the reply,so that's it your not suppose to take these things apart that's why there are no specs. On line everyone deviates the...
Picture of the new disk [ATTACH]
Will be installing new clutch with a Kevlar lined disk
Like we can see this one was full of gear oil and not grease [ATTACH]
im rebuilding a voith damping flywheel and i can't find the torque specs for the 6 bolts that assemble the unit to the flywheel
There's a gold connectors set for the fuse box?
Not the relay I swaped it I just wanted to know if these fuse boxes have problems along the welds where the terminals are
So here we go went to a car show parked car after one hour car didn't what to start. lucky I have some mec skills so I quickly realized that my...
Just replaced a f1 clutch 98 355 the clutch sliped bad at take off and after minutes of driving a beaping sound at take of in first gear that's...
I did one on a 95 355 and it worked just fine like you could see the spring are not perfectly straight but don't leak and works great. The flange...
Wanted to know if anyone ever used permatex 51580 instead of loctite 574 to glue engine case together because here in Canada it seems like I can't...
