© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
John, a couple of things to think about. First, the idea is to have a press fit so the gear is tight on the shaft even without adhesive. Secondly,...
John, Your idea is very clever and thank you for taking the time to post the graphics for clarity. Inspiring! The challenge is the original disk...
Ian, If you need one of the gears, just PM me and let's get you set up. You will have to turn down the end of your worm gear in order to fit the...
I moved forward with drawing up the little gear and having a couple made. It took two rounds to get the mesh with the pinion gear perfect. The...
To be clear, I was referring to a non-working 63307100. :)
Hi all, Happy Holidays! My vent direction motor assembly 63307100 is back in the F355 and working well. However, with the straight-cut gears,...
After looking into various options on replacing the problematic gear, I decided to take a different approach. I was able to source a 45t 0.5 mod...
Hi Rob, I'm in the same boat as the others. Please add me to your list. I'm close to preparing a CAD myself and paying to have a few gears made...
Alex, Sent you a PM! Take care, Jim
Shootfighter, I wanted to share a couple of things with you. First, there is a procedure in the service manual that describes an approach...
Hi Everyone, I've just replaced my worn CV boots and it's time to torque the upper and lower control arm bolts that run through the wheel hubs....
Hi Everyone, The foam insulation sandwiched between our 355's deck lid screen and the lid itself is coming apart so I'd like to replace with...
Hi Dave, That is a good find. Thanks very much for posting the link. Good luck with your 355 search. 355's are a hoot! Jim
Got it! First, thanks to Ron for the helpful videos and to everyone for their comments. I placed the car on the ramps and then moved the gear...
Ive got some time set aside tomorrow to sort this out and will post the results. Ron, it would be helpful to review your videos if you would not...
Dear All, Got the F355 back from a major a few months back and gear engagement (manual) has not been as smooth as it used to be. Ive got...
Receiver found, installed, and working wonderfully! Thanks to all who PM'd! Jim / F-86
Here is a photo of the small vacuum pump (from the previous post) that can be used to test the bypass valve and the vacuum circuit in general....
Dear Mitch, Each bypass valve will have slightly different characteristics, and as some have mentioned, time and temperature can cause the...
Hi Everyone, My Sony XR-F20 (XR-C720) receiver in the 355 has died. Sony Laredo took a look and reported the main chassis is fine but the...
