© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Makes sense, thanks.
Finally got around to changing my timing belts on my 360 last weekend and found an empty metal container thing mounted on the bulkhead in front of...
I think you will find the odometer will be correct. There would be regulatory issues if it wasn't. My speedo is 10% high on stock tyres. Kind...
No chains on this engine so this is not relevant. You are just looking at the gauge as the piston is going up and detecting maximum height.
Spotted in Munich during Oktobefest 2019. [ATTACH]
Errrr, you have a serious problem !
I don't think you really mean "hole" do you?
On the top face yes, they are all slightly different due to gear lever angle. They may all be the same on the lower face.
Gotcha, all to do with draft angle. OK, I would make the finger between reverse and second 6.7 mm and the reverse slot 11.5mm, that will eat the...
Unless I am misunderstanding your question you should already have all those dimensions. All finger widths are the same @ 5.7mm. Slots are all...
I would get one 3D printed and test fit before making the real thing !
God knows where he got those dimensions. They are garbage or my car is different. All dimensions top face. Total width = 90.6mm Total length =...
Right edge to inside 5th slot = 13.7mm Bottom of slots to bottom edge (rear of car) = 27mm Finger width = 5.7mm Right hole to edge = 13.4mm Phil.
The engine was cutting cylinders to control the wheelspin.....
I prefer mine in gold but of course I'm biased.... [ATTACH]
Can you try a new fuel cap ?
Have you tried bleeding it ?
If you are handy with a soldering iron and depending on amount of damage to the board it maybe possible to remove the battery and convert to a...
My thinking (and my hope as I have a 6 speed) is that the manual transmission version will, over the long term, be worth more. There are less...
According to the wiring diagrams all of the wires in the connector seem to come directly from the RH Motronic ECU, have not managed to locate a...