© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Alberto, I still have a few sets, so if you know of anyone that might need them, they can contact me at [email protected]. Thanks, Steve
Tony, Thanks for your thoughtful response. At least the photos are there helping to explain what the "cups" are and where they are located in...
Alberto, Did you try and contact me recently concerning availability of the Dino 246 Jack/Triangle Cups? Threads were taken down in the Dino...
OK, well explained. The misunderstanding was on my part. Steve
I just wanted to report in this section (first reported in 206/246 section) that a NOS Dino 246 head was measured at 124 mm head thickness. Still...
Measuring the thickness against the specification is the only accurate way of determining whether a cylinder head has been milled or not. There...
Thank you so much for taking the time to get the measurement and take the photo. We picked up the heads today from being disassembled and cleaned...
That would be wonderful. And yes, the proper measurement is as you describe. That is the main measurement we need. Our valve seats don't look...
Yes, that method will let you know the valve to piston clearance (with compensation for the head gasket) and is especially helpful when installing...
I posted the same question concerning the Dino 246 heads today. As has been stated, the head thickness specification is just not published. So...
We are in the process of prepping a 246 engine for a complete rebuild and cannot find the factory specification on the original head thickness....
Should anyone have a blue top for the "triangle case" as posted above just collecting dust I would be interested in purchasing it as mine has been...
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
I was at the shop today and took some photos and measurements of the "straps" as follows: --the jack bag and emergency triangle retainer straps...
Alberto, Mine are in good shape so will post a photo when I return from the shop tomorrow (6-22). There are 3 straps in my 02654 (1971 early "E"...
Good point Ron. Trying to schedule a meeting with the molder next week to determine some final pricing and specifications. He has suggested...
Thanks for the conformation, Lain. I have a meeting scheduled this week with the molder to go over final numbers. Will report results on the...
RonG, normal fitment for LHD puts the jack on the right side of the car and triangle on the left. I have access next week to a RHD Dino which I...
OK. They were apparently used on the "M" and early "E" series. They were riveted to the underbody panel directly below where the jack bag and...
To the best of my knowledge these black plastic cups that secure the bottom of the jack bag and emergency triangle case are not available and most...