© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I have had great success with Idle 50 and Main 140 with Shell V-Power 98 here in Norway (98 because this likely contains no ethanol here in...
Measured mine, no difference while turning the axle. Changed "C1" and "D1" and now it jumps from 4.. to 11.. Hope thats it and that the speedo is...
Fantastic.
Loctite 3020 (spray) is great if you want to get the gasket to stick to the surface while mounting, it also improves sealing. If you want to add...
Also check the bushing and rod (steering Column Plug Extension) where the steering rod goes through the floor in the car. To eliminate the play I...
First: https://www.facebook.com/DriveTV/videos/861058660677077/ https://www.facebook.com/DriveTV/videos/861527407296869/ (DRIVE coverage of...
Heres a picture of the Coverking Stormproof. [ATTACH]
I bought a Stormproof Cover King car cover from Car Covers Covercraft Custom, Coverking Truck Seat Covers, LeBra Car Bras, Dashmat Dash Covers,...
The plates in the last picture is just the same as in my car.
Look in the engine room. My 308 Gt4 (sold in Switzerland) have a similar plate in the door jam, VIN on the steering wheel column housing and a 3...
Early 308 Gt4 shares more parts with the 246. Early models had: - Different mounting for steering rack - Different differential (up to gearbox...
As you can see Part#1 and #3 are two piece, not one piece as on your car. Part #4 and #5 are standard bearing parts that you can probably get from...
I am also fixing these bearings at the moment. Below is a picture of all the parts, with numbers so it will be less confusing to discuss the...
I have not serviced the wheel bearings so I do not know where to get that tool. Superformance have a lot of tools listed on their website:...
The inner part does not have to be one piece. I guess you could replace these with the original two piece parts. Where do you live? I prefer...
You also have to make sure that the both sides are in line (the one you are welding and the other one). If there is too much play between the...
These outer bearings (rear) are not similar to the inner ones. You do not want to replace these with rubber. The bushings are DU teflon coated...
What is the easiest way to remove the radiator fans? Anyone serviced one of these? One of mine is making a lot of noise.
It might have been easier if I had removed the cams, but I was not 100% confident in the procedure and did not want to risk damaging one of the...
The movement was visible, many millimeters. Unfortunately I did not record the measurements, just focused on the lowest number.
