© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Normally, a (separate) TC controller acts on the injection signal. If traction is lost, one or more injection pulses are disabled until traction...
This means that the display misses the signal from your TCU. And this that your TCU is not fully blown (unless it is a continuous beep). Did...
I could probably change that.
Hi there, I'm looking for a way to get my hands on a Bilstein Fiorano shock ECU (p/n 175948). My dealer tells me it is not available anymore. Any...
There is not much more you can do except throwing parts at it. Last option would be to test the solenoids for leakage. The solenoids have two...
Which makes the diagnosis stronger. Take care to maintain the adjustment of the valve! Moreover, do not loose any parts! [ATTACH] [ATTACH]...
I assume that you either have (1) air in the system, (2) a bad accumulator or that there is (3) an internal leakage in your hydraulic block. As...
Your transducer works fine. There is no link between the sensor signal and the stop of the pump other than the pressure. So if the signal drops...
Is your gearbox in neutral right now?
Grab a Voltmeter and test it! It's pin 51 against ground (e.g. pin 20). According to the WSM, the sensor output is 0,5V plus 1,0V each 20 bars....
According to https://www.ferrarichat.com/forum/posts/147079085/ a flashing display indicates that the gear position is out of bounds. I'd suggest...
Yes, the warning light for the suspension is still there. Error codes are: "actuator locked", which in my understanding might indicate an issue...
Thanks for your reply, @Qavion. I meanwhile got myself in the footwell and identified the relay. It is the one that drives the Air Pump. There...
Hi there, When driving in my F355 I notice a weird noise. It sounds like the "click" sound of a relay and it always appears when the accelerator...
My SDX is of version 2.0. There is an USB port, but it works as an Ethernet bridge (if I got that correctly). So it's different there. However,...
Thanks. In my case SDX is searching my USB for a virtual COM port. Unfortunately, I have issues with my USB and so it fails. It complains and...
How does an SDX Diagnostic Tester connect to the computer? Is it possible by USB cable only? Or does it support other connections like Bluetooth,...
Is there anyone who would be willing to contribute the SW for an SDX 2.0? Right now, there's only the SW for the normal SDX available in the...
Thanks, guys!
Hi there, I have a Galileo Diagnostic Tool. Whenever I connect it to the Motronic and fire up my engine, it first runs for one or two seconds and...
