© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
These two couldn't be more different other than they both have large butts. Spent Sunday giving them a good clean. 20250627_144122 by N17RO...
Having gone through this test just today I can confirm that the interior cabin ambient temperature sensor part No. 61079100 can be replaced by an...
Just to confirm it was 100% the interior cabin ambient temperature sensor that was faulty. The new Adafruit 10k B3950 NTC Thermistor Temperature...
Hi all. I've ordered an Adafruit 10k B3950 NTC Thermistor Temperature Sensor which has almost identical resistance numbers across the temperature...
I put new ones in. One of the old ones had ceased in place so the entire fitment had to be removed and machined. For the 134a I'm using a 30lb...
Thanks Joe. Checked and the clutch does engage when directly connected.
Hi Steve, I've removed the sensors from the dash. Its actually broken hence there is no reading. No idea how it could have been when the new...
To update the above Ive tested again the sensors as pin 1 to 4 kept fluctuating. Ambient temp is 38 DegC Pin 1-2 should read 5777 ohms and I get...
To add to this I have also now checked the following which I found on another post from @Steve Magnusson There is a relay on the AC unit that...
So I have the schrader valve now fixed and have just started the car to fill it. However the compressor clutch is not engaging when its being...
Sure Guido, I took a dremil to the inside top and bottom edges of each fuse location then tried to fit them. Kept doing this till they just went...
Thank you for posting the photos Guido. I actually used a Stanley knife to cut the white connectors. Put them on my bench and just pressed down...
Thanks all. It is indeed the schrader valve. Ill try and tighten it this week see if it helps. If not Ill find a replacement as I've recovered the...
Hopefully this image can be seen. 1000098938 by N17RO posted Jun 18, 2025 at 4:38 PM [IMG] [IMG]
Hi Joe, thanks for point it out. I seem to have having posting photos these days. I can see them on the posts. Im using fchat for hosting them so...
Hi all, After doing all my seals etc and changing over to 134a gas as R12 is now banned where I live, I know have a leaking valve on the...
Hi all sorry for the late reply been too busy these days. No idea why the photos arent showing to some people. They are the same format I always...
Hi all, As some of you will know I kept getting some very hard to trace electrical issues. The car went through about 3 fuel pumps in a short...
Just to follow up and close this. Today I bypassed the fuse box for the fans and fuel pumps and the car runs perfect again. I've already...
When I opened my panel I was surprised to find the fans and pumps wires are already hard wired to the panel. They were passing through the...