© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
355 gear box cover plate is gone.
.. and a white 308 fuse block that shows no sign of melting, terminals could use a little scotchbrite, this appears to be the left side (ie for...
I now have some black zinc plated full thread 6x1 and 8x1.25 flange bolts (bolt and washer in one) that are a good subs for factory steel bolts in...
Correction, the small diameter screws I have are indeed no 4, which are correct in comparison to the originals with the minor cosmetic difference...
i have both the #4 for louvers and #2 for interior trim.
I got the banana/kidney vent. But I now need the little vented cover plate for the flywheel on an F355.
To answer the question about the small trim screws, the thread is identical; the head is almost imperceptibly smaller; the length is 20mm vs the...
I have all the harnesses for a 95 manual shift
Have a F355 clutch thrust bearing assy, used, doesn't feel rough, I went to a Hill Eng upgraded bearing so this one is avail for $100 plus $15...
I get the fire hazard ... which I believe was intentional as this wasn't the only fire hazard we found when I took possession of the car .. but I...
I bought a Hill Eng 355 thrust bearing so that comes off the list.
But I now need an F355 thrust bearing assy, mine is screeching.
I located a banana vent, so that's off the list.
One thing I noticed, not obvious from the photos, is that genius no 1 did not connect the top crossover tube to the filler neck. The stock car is...
I had to rebuild my Lucas cooling fan ... found a source for brushes identical to the OEM brushes, precurved. Had to buy a bunch of them. Selling...
Photos [ATTACH] [ATTACH]
I bought a borescope and am going to take a look from the filler and and the vent end. I think the problem is the crossover vent is a rather small...
I wondered about that. I am pretty sure I did put a piece of coathanger wire in there and will try that again just to be sure. The geniuses that...
There is nothing connected to the 3 vent tubes. All that DEQ stuff is gone. It looks like it should work as is, but it doesn't. The filler neck...
Modified filler is extremely slow, pump clicks off repeatedly unless I just trickle it in. Is this a symptom of poor venting? The filler neck was...