© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Have you already checked the safety relay and fuse in right rear fender? Check this link: http://www.ferrarichat.com/forum/142571060-post10.html
Have you mixed DOT 5 hydraulic fluid to DOT 3 or 4? That is very bad for hoses etc...
This is picture of my setup. 5.5 bar = 80 psi, seems to be ok. Have you checked throttle linkages, all is tight and there is no backlash? [ATTACH]
That screw is very sensitive. I would say that 1/16 turn would be 0.1% in CO. After adjusting, plug that screw hole and wait 10...15 seconds...
Ok. When these symptons started? After you installed new plugs? Second place to check is intake leaks. Maybe you have some rubber connection loose?
High HC indicates faults in ignition. Check again spark plug extenders (measure ohms), spark plug wires and check connections inside distributor...
Here is my 88.5 Testarossa's Blaupunkt, Memphis SQR 06, plus amplifier. All Works fine, but radio audability was not really good. So I decided to...
Thanks Tim! This was just, what I was looking for! I have Motip semigloss paint, I think it is very close to original glossy.
Yes, this method can also be used, but I am just curius, how they did this in the factory?
Hello all, My cars previous owner has painted the area behind the front grill to red for some reasons. I am pretty sure, that is not original...
Why you have a hammer in that picture? It is totally wrong tool in auto garage!
Idle speed setting procedure can be found from Workshop Manual. If you have KE-Jet, use 'workshop Manual Supplement For Variant With Catalytic...
Nice retro video, haven't seen this before: MotorWeek | Retro Review: '88 Ferrari Testarossa http://youtu.be/ymEGXGZS1cQ
I am afraid you cannot use Mercedes part without tuning them. Please read this older post:...
In the picture you have EHA (Electo-Hydraulic-Actuator), not fuel pressure regulator. Which is right part for you? Between the fuel distributor...
Are you sure that your tachmeter is working properly?
This was right solution, thanks. Yes, I disconnect both ECU and turn throttle full open, also turn metering devices open. But I was not able...
Hello, I am planning to do compression test for my engine just for curiosity. I found this thread:...
Not any special. Just dial indicator, tweezers, torx wrenches. And maybe able to use ultrasonic cleaner is helpful. My another fuel distributor...
I did the rebuild-project for both distributors at last week. According the great help, everything went well. Not a hard job, if you have all...
