© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
The quad rings are available in the UK and last time I checked we were geographically in Europe:) See link for size that fits. I've used these...
The static pressure/temp balances with the air temp, so you have enough refrigerant in the system for the system to provide some cooling. And the...
IF the system is mixed with OAT and IAT glycol, the two are not compatible and could turn into an Orange sludge. As mentioned above, flush it...
The static pressure does look ok. Suggests a gas temp of around 31 deg C. Was this similar to the air temperature around the system? There is a...
Mine's an October 88 build. I don't have a pic of the left hand cylinder rotor position. But it should be pointing in the same direction as the...
With the timing marks set at No 1 cylinder TDC, the rotor position is this... But I think Steve's response is more likely to be the issue. [ATTACH]
No, not to get an accurate reading. The pressure drop (resistance) through the air filter needs to be present, for a true representation of the...
Yes, remove the slotted screw, then you will access to the adjustment. I wouldn't attempt this unless you have access to professional emissions...
It is between the fuel distributor and air filter, underneath a screw, that you need to remove. There may also be a seal above the screw, but...
That's assuming the unbranded Superformance bearings are to the same spec as original ones.
What clearance spec are the bearings? (CN, C2, C3 etc), and does the spec match an OEM bearing?
The original Cavis 400 leads would have been 0.5 k ohm-1 k ohm. Modern resistive replacements are more like 3 k ohm - 5 k ohm. In both cases the...
Those are Gold Palladium plugs and the correct grade. Very odd that the lettering is not consistent. I would be leaning towards thinking Fake....
. According to the history, the spark plug cables, extenders and spark plugs were replaced 2 years ago. Any suggestions? Before you dive too deep...
I don't recommend that you try this ferry!!..... https://www.facebook.com/share/v/1BFF6ywmD6/?mibextid=wwXIfr
Hence why the metal to metal dip stick tube to union olive must be oil tight.... [ATTACH]
Take a look at this. It may help you......
Michael, if you struggle with that, I can recommend this....
These are the X rings that fit a 328, which I think are the same size for your 308QV. There is no need to remove the swaged washers....
That's interesting. Where the spec is the same, this is mentioned (attached). Which page are you referring to that shows different values for the...