© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
No, the third paragraph lists ovalization and taper limits. Sent from my iPhone using FerrariChat
Page B12 of the shop manual has the spec for liner taper to not exceed 0.010 - 0.015mm. This can be measured with a dial bore gauge. [ATTACH]...
…although GTB front turn signal lenses are an unfortunate oversight! Sent from my iPad using FerrariChat
No I think what he is saying is that if you are going to bore/hone the liners in the block then mark the liners for each hole and their...
Interesting color combination on this one. Very nice example. Audio is in German. [MEDIA] Sent from my iPad using FerrariChat
As far as I know the liners on my engine (‘75 GT4) had no coating. Later models may have had nikasil coatings. Sent from my iPhone using...
You should be able to check for roundness within factory spec after boring/honing. My machinist had to make a fixture to stop the walls of the...
Will definitely try next time. Using a puller requires a crazy amount of torque and I am always worried something will slip/break and crack the...
[ATTACH] Sent from my iPhone using FerrariChat
[ATTACH] [ATTACH] Sent from my iPhone using FerrariChat
Installed. Reminds me of fishnet stockings :-0 [ATTACH] Sent from my iPhone using FerrariChat
Benzina is gasoline in Italian? Fiats used Jaeger gauges in the 124 era but probably had Veglia in the mix at some point too. Sent from my...
Cleaning up muffler grill before paint. Almost too pretty to cover up. [ATTACH] [ATTACH] Sent from my iPhone using FerrariChat
I installed the Pertronix pictured on my GT4. Simple installation and works great. Looks like a stock setup. I do use +12v for coils direct from...
I don’t recall tdf blue being a color available for a GT4. Blu Sera looks amazing as does Blu Scuro but as mentioned there a many great options...
I put a NOS pair of doors on my GT4 that were still in factory primer and I don’t recall the body shop using a lot of bondo to get them straight...
GT Car Parts in AZ may have one. Sent from my iPhone using FerrariChat
What country are you in? Sent from my iPhone using FerrariChat
I took a gauge apart on my 69 Alfa Spider and it was a painfully slow process and found it very difficult to reinstall properly without a press...
Just be sure the doors are refitted to the car to check gaps before painting. The previous owner of my GT4 had the doors “repaired” and the...