© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
You are correct on both counts, the gasket goes on either way (I smear just a dash of non-hardening sealing compound instead of the usual oil) and...
Not my garage, unfortunately! It's the shops latest investment, right after they finished our car. At least I know what they did with all the...
Ours just got repainted in the original Rosso Dino, aka "orangish" :D [ATTACH]
If you can rig up (or buy since it's not very expensive) a waveform generator and have it output a square wave, it would allow you to directly...
Just installed mine, an SD5. From the Sanden FAQ:...
Hi, the large panel is riveted on, but there are small access holes where the cable enters and exits the tubes. Also, there is a trap door just...
I'm really impressed with the work that went into this registry, it's the most complete (afaik) concerning our '74 GT4. It even has the right...
Hi, I'm also looking for an early (2 distributor) Euro GT4. Any hope? Thanks!
This works great for removing surface yellowing on plastics, but probably won't do much for polyacrylate. Also, it's good to add a catalyst to...
I used a sticky thin butyl strip that comes in a roll. The advantage over a butyl caulk it that it does not run and make a mess as you try to...
I can't find many pictures of GT4's in Rosso Dino. Is this one Rosso Dino? :D [ATTACH] [ATTACH]
Is that like the Porsche 911 yearly updates?
I found it at retrorosso for a little cheaper: https://www.retrorosso.fr/xtc/Ferrari/60-Vitres-joints/Portes:::15926_17224_17225.html
Thank you!
A few measurements later, it's an aluminium alloy, not SS. Still not sure about the finish though.
Hello, After restoring the engine, I've embarked on a full bare-metal restoration of the body and sun-roof delete. I have a question about the...
Very good write-up! I can add that, if the motor coil is burned out (like mine was) and the fan no longer working, it's possible to manually...
Are we sure that it's the motors not doing enough because of the hardened grease, and not the window channels that are hard and grimy? I took my...
Based on my on-going first-hand experience of full bare-metal restoration of our GT4, I can say that this looks really all too true! Not much...
Insomuch as the cams are connected to the crank, I installed a lumenition pick-up as described by Adrian for the Fiat Dino and 308's and it's been...
