© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Your making me miss my old NSX so much. I still have a set of 17F/18R wheels I bought explicitly for a 'future' NSX. Hopefully someday I can use them.
Ugh this garbage again. Can we just ban this website. Garbage AI articles If not AI, this 'writer' needs to find a new day job.
I have been looking for PN 177023 for a while without success. They used to be much more available as everyone wanted the horse. I would be and...
I thought the 512TR used a plastic impeller. If brass agree !
183759 is the revised 512TR part. I know an upgrade aluminum impeller exists for early cars. Is there one that likewise exists for cars that...
Restrictions and effort if already swapping H pipe is minimal
Then I would get the H pipe and over axle pipes but leave your mufflers
My understanding that the alternator on a 512TR (PN 154153) is a standard/generic Delco until in an application specific housing. I think it is...
For low growl, you definitely need to replace the OEM center muffler on an early (pre midpipe delete) 575. You didnt mention your SN so not sure...
In effort to generate funds for my HGTC retrofit project, I will be selling my 512TR Stage 3 Capristo + Test pipe. Both were used less then 50...
In aside, may I assume your narrow 3 hole across brake/clutch pedals are aftermarket?
Nice! I’m going to give them a call next week and see what they can do to help out
I think they would look great.
My 94 512TR is due for her next major and I wanted to assemble all the parts in advance. I am planning belts + waterpump rebuild + fuel system...
Correct, sorry should have added that I was adding context about what similar look like in the 575 as its rather rare to see in those cars. I...
Standard seats aka "none Daytonas" are uncommon: Here is what they look like. [ATTACH] [ATTACH]
Left most side sitting out too far
They weigh less than my OEM 19in modular wheels (actually closer to my factory 18in Al wheels)
As I had several messages ask: Yes I have a pair of fronts available as well. I had a set custom barreled with forged lips/inners explicitly in...
Each his own, I remain partial to the Hamann/OZ PG3s in 355 specific size: [IMG] [IMG]
