© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
You would not believe how much lead is in these cars. The rear panels are full of it and mine have it about 5mm thick around the hood and trunk...
I didn't say it's not a common procedure but it does require a few special tools/parts to do it right. It is a job I have done as I don't have...
I kept the old one, but looking at how much they have gone up I will hang on to it. I purchased the new one in Nov 2016 and it was only $218...
Have you tried Ferrari for the pump cover? I needed one for one of my cars previously and was on a waiting list with Ferrari for about 18 months...
If you replace the timing chain keep in mind the camshaft alignment marks are just an assembly guide and there is quite a complex procedure for...
I used two stands bolted together but had to cut and weld the upright posts to change the angle of the tube as the ones I used normally have the...
Where is the 365, 400 312 in the celebration of the front engine V12 Ferrari's??? :(...
I assume you have checked the fans are wired up correctly and push air in the right direction - if wrong they will draw more current when the car...
So sorry to read this Pap. Wishing your family a speedy recovery. I had a phone call from Aileen Friday week ago and all I could hear was her...
When I did mine I tried various materials including ABS (ABS was worse than tempered PLA) none of which stood up to the central Australia sun...
Thanks Sam, I'm new to seal packs but I assume they would go in this configuration (fluid side of shock on bottom) with one of the flat steel...
Hi Sam, I'm rebuilding my front shocks at the moment and would like to know what seals you used for the number 2 seal pack please. Do you also...
Some interesting information on this site - https://forum.365gtc4.com/forum/main-forum/9439-rear-shock-nitrogen-psi and an explanation of how the...
I found the cause of my chewed up flywheel. The WOSP LMS029 starter motor I have been running on this engine for 8 years (not that many Km's...
If they could design a drop in unit for a reasonable price I would be interested in 1 or 2. It would be nice if it was a complete kit from...
I needed to take the front wheels off to give me more space to work and thought hub stands would be ideal but the only commercially available ones...
Ha Ha! But they still start with an "F" :) I wouldn't attempt cutting this much rust out of a Ford though. I really understand why Aussie...
I replaced the lower edge of the rear panel today as it had rusted off. I tried out some new (to me) panel clamps for butt welding panels together...
The rebuild is progressing - slowly but progressing. :) The new boot floor went in very nicely and is a good shape compared to the original but...
Hi Robert, All the best for the new year to you as well. The shell provided lots of good parts as this one needed both front and rear windscreens...
